Redes

Procedimiento de recuperación de contraseñas Switch Cisco
Procedure with Password Recovery Enabled
If the password-recovery mechanism is enabled, this message appears:
The systemhas been interrupted prior to initializing the flash file system. The following
commands will initialize the flash file system, and finish loading the operating systemsoftware:

flash_init
load_helper
boot

Step 1 Initialize the flash file system:
switch: flash_initStep 2 If you had set the console port speed to anything other than 9600, it has been reset to that particular speed. Change the emulation software line speed to match that of the switchconsole port.
Step 3 Load any helper files:
switch: load_helper

Step 4 Display the contents of flash memory:
switch: dir flash:

Theswitch file system appears:
Directory of flash:
13 drwx 192 Mar 01 1993 22:30:48 c3750-ipservices-mz-122-25.SEB
11 -rwx5825 Mar 01 1993 22:31:59 config.text
18 -rwx 720 Mar 01 1993 02:21:30 vlan.dat

16128000 bytes total (10003456 bytes free)Step 5 Rename the configuration file to config.text.old.
This file contains the password definition.
switch: rename flash:config.text flash:config.text.oldStep 6 Boot up the system:
switch: boot

You are prompted to start the setup program. Enter N at the prompt:
Continue with the configurationdialog? [yes/no]: N

Step 7 At the switch prompt, enter privileged EXEC mode:
Switch> enable

Step 8 Rename the configuration file to its...