Redes
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#host Pipe
Pipe(config)#enable password pipe1Pipe(config)#enable secret pipe2
Pipe(config)#no ip domain lookup
Pipe(config)#banner motd #
Enter TEXT message. End with the character '#'.
--------------NO ENTRAR---------
#Pipe(config)#line console 0
Pipe(config-line)#password pipe3
Pipe(config-line)#login
Pipe(config-line)#loggin synchronous
Pipe(config-line)#exit
Pipe(config)#line vty 0 4
Pipe(config-line)#password pipe4Pipe(config-line)#login
Pipe(config-line)#exit
Pipe(config)#interface fastethernet 0/0
Pipe(config-if)#ip addres 203.150.182.254 255.255.255.0
Pipe(config-if)#descrption lan Pipe^
% Invalid input detected at '^' marker.
Pipe(config-if)#description lan Pipe
Pipe(config-if)#no shutdown
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Pipe(config-if)#
Pipe(config-if)#exit
Pipe(config)#interface serial 0/0/0
Pipe(config-if)#ip addres 196.153.165.1255.255.255.0
Pipe(config-if)#description ENLACE A BORRE
Pipe(config-if)#clock rate 64000
Pipe(config-if)#no shutdown
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to down
Pipe(config-if)#exitPipe(config)#router rip
Pipe(config-router)#network 203.150.182.0
Pipe(config-router)#network 196.153.165.0
Pipe(config-router)#end
%SYS-5-CONFIG_I: Configured from console by console
Pipe#Pipe#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
Pipe#
Pipe#
Press RETURN to get started!
Router>enable
Router#configureterminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#host BORRE
BORRE(config)#enable password borre1
BORRE(config)#enable secret borre2
BORRE(config)#no ip domain...
Regístrate para leer el documento completo.