Regulador Carga Solar

INSTRUCTION MANUAL
----------For solar charge controller,
----------EPRC-MF

series
IP67

RATINGS (12V or 12/24V auto work)
EPRC-MF-10 12V or 12/24V auto-work, 10Amp
NOTES: For use with solar panels only

TECHNICAL INFORMATION
12Volt

24Volt

Rated solar input

10A

10A

Rated load

10A

10A

25% Current overload

1 min.

1 min.

Load disconnect

11.1V

22.2VLoad reconnect

12.6V

25.20V

-30mV

-60mV

Temp Comp.(mV/℃)
Temperature:

-35℃ to +55℃

sealed

flooded

Gel

High voltage disconnect

14.2V

14.4V

14.6V

Equalization voltage

14.4V

14.6V

14.8V

Float voltage

13.7V

13.7V

13.7V

QUICK START INSTRUCTIONS
This section provides a brief overview of how to get started using the controller.However, please
review the entire manual to ensure best performance and years of trouble-free service.
1. Mount the controller to a vertical surface. Allow space above and below the controller for air

flow.
2. Make sure the PV and load currents will not exceed the ratings of the controller being
installed.
3. It is recommended that the connections be made in order from 1 to 6. (see thefollowing
picture)



Use with 12V or 24V batteries only
Use with 12V or 24V systems only

4. Connect the BATTERY first. Use care that bare wires do not touch the metal case of the
controller.
5. Connect the SOLAR(PV array) next. The green LED indicator will light if sunlight is present.
6. Connect the LIGHT last. If the red LED indicator lights, the battery capacity is low and should
becharged before completing the system installation
7. Press the BUTTON 0 or 5. to verify the system connecting.

LIGHTING CONTROL OPTIONS

LIGHTING CONTROL OPTIONS
•

LOAD ON TIME SETTING:
Press the setting key, and the led will repeat from LOAD ON TIME SETTING, DELAY TIME
SETTING and BATTERY TYPE SETTING. Press the key for 5 seconds when the led is on LOAD

ON TIME SETTING, the numberwill flash, and choose one number as following setting until
it is still.
0
1

Light is turned on for 1 hour after sundown

2

Light is turned on for 2 hours after sundown

3

Light is turned on for 3 hours after sundown

4

Light is turned on for 4 hours after sundown

5

Light is turned on for 5 hours after sundown

6

Light is turned on for 6 hours after sundown

7Light is turned on for 7 hours after sundown

8

Light is turned on for 8 hours after sundown

9

Light is turned on for 9 hours after sundown

0.

Light is turned on for 10 hours after sundown

1.

Light is turned on for 11 hours after sundown

2.

Light is turned on for 12 hours after sundown

3.

Light is turned on for 13 hours after sundown

4.

Light is turned onfor 14 hours after sundown

5.
•

Dusk-to-Dawn, light is on all night

Lights remain turned off, ON/OFF mode

DELAY TIME SETTING:
Press the key for 5 seconds when the led is on DELAY TIME SETTING, the number will flash,
and choose one number as following setting until it is still.
0
1

Since its dusk, the lamp will be on after 10 minutes.

2

Since its dusk, the lamp will be onafter 20 minutes.

3

Since its dusk, the lamp will be on after 30 minutes.

4

Since its dusk, the lamp will be on after 40 minutes.

5

Since its dusk, the lamp will be on after 50 minutes.

6

Since its dusk, the lamp will be on after 60 minutes.

7

Since its dusk, the lamp will be on after 70 minutes.

8

Since its dusk, the lamp will be on after 80 minutes.

9
•W ithout any delay, lamp is on after dusk.

Since its dusk, the lamp will be on after 90 minutes.

BATTERY TYPE SETTING:
Press the key for 5 seconds when the led is on BATTERY TYPE SETTING, the number will flash,
and choose one number as following setting until it is still.
1

Seal lead acid battery

2

Flooded battery

3

Gel battery

LED INDICATOR
Charging indicator...