Smartpack Controllers

User's Guide

Smartpack Controllers

Monitoring and Control Units
Powerpack, Flatpack2 & Minipack
DC Power Supply Systems
350003.013

.

1 Introduction
Information in this document is subject to change without notice and does not represent a commitment
on the part of Eltek Valere.
No part of this document may be reproduced or transmitted in any form or by any means — electronic
ormechanical, including photocopying and recording — for any purpose without the explicit written
permission of Eltek Valere.
Copyright ©: Eltek Valere, 2009

NS-EN ISO 14001 Certified

NS-EN ISO 9001 Certified

Certificate No:
11276-2007-AE-NOR-NA

Certificate No:
4072-2007-AQ-NOR-NA

Safety Precautions
 The equipment described in this manual must only be operated by
Eltek Valerepersonnel or by persons who have attended a suitable
Eltek Valere training course

 The equipment represents an energy hazard and failure to observe this
could cause terminal injury and invalidate our warranty

 There are hazardous voltages inside the power system. As the modules
incorporate large charged capacitors, it is dangerous to work inside the
system even if the mains supplyis disconnected

 Products into which our components are incorporated have to comply with a
number of requirements. Installation is to be in accordance with the
recommendations herein



Please read the manual carefully before using the equipment

350003.013

Issue 7.0, 2009 June

Published 2009-06-12
Mfm

2

User’s Guide Smartpack Controller,

350003.013, 7v0-2009-06

1Introduction

Table of Contents
1.

Introduction

5

About this Guide ............................................................................................................. 5
System Diagram
Flatpack2 Power System ................................................................ 5

2.

Control Units

6

CAN bus............................................................................................................................... 6
CAN bus Addressing ....................................................................................................... 6
Software Assignment — Rectifiers ............................................................................6
Hardware Assignment — Control Units.....................................................................7
CAN Bus Address Range — Control Units................................................................7

CAN bus Termination ...................................................................................................... 8
Configuration — Control Units ........................................................................................ 8

3.

The Smartpack Controller9

Key Features ................................................................................................................... 9

Block Diagram ..................................................................................................................... 9
Typical Applications...................................................................................................... 10

Location of Connectors & Communication Ports .......................................................... 10
System & Battery Signals
Internal Connections ....................................................... 11
Alarm Relay & Digital Input Signals
Customer Connections .................................... 12
CAN Port Signals
InternalConnections.................................................................... 13

Installation of Smartpack Controller .............................................................................. 14
Safety precautions ........................................................................................................ 14
Mounting and Removing the Controller......................................................................... 14...