Título

TO REPLACE THE BATTERY:

REMOTE TRANSMITTER

The Nova system incorporates code hopping technology to offer ultimate security in a remote control.Rotate the inner casing (Fig. 1) and remove it from the outer clip (Fig. 2).
Fig. 1

It is NOT necessary to open this transmitter to code the unit as italready has a unique code. To make this unit functional, the receiver unit must memorize its unique code as described below: FOR PULSED OPERATION: 1. Open thereceiver unit, and WITH POWER ON, bridge the “Learn” jumper. 2. The red LED will now illuminate 3. Press the required button on the transmitter. The red LED willflash once, indicating that the button has been learned. 4. If further buttons are to be memorized, repeat from step 3. If not, remove the bridge from the“Learn” jumper. The system is now ready for use. FOR LATCHED OPERATION: 1. Open the receiver unit, and WITH POWER OFF, bridge the “ERASE” jumper. 2. Power up theunit. The red LED will now illuminate 3. Press the required button on the transmitter. The red LED will flash twice, indicating that the button has beenlearned. 4. If further buttons are to be memorized, repeat from step 3. If not, remove the bridge from the “Erase” jumper. The system is now ready for use.

Fig. 2Fig. 3

Using a coin, separate the two halves of the case (Fig. 3) Replace battery with type GP23 or similar.
I M P O R T A N T: Ensure that the b a tt e r y i s c o r r e c t l y i n s e r t e d , according to the diagram.

1031.D.05.0009_3

CENTURION THE AUTOMATIC CHOICE
www.centsys.co.za