Tarea

Introduction
200KT series elephone alarm system adopts 8-bit single chip as a processing core. It can intellifently identify the singnals sent by human body. When someone enters into the defense area, the built-in dialer will automatically dial the alarm informed telephone (or pager) number. Therefore, it is suitable fot warehouse, bakns, museums, archives, families, markers, etc.
Functionsdescription
Low wrong-alam rate, adopting processing technology of integrating dual infared sensors and chip for double intellectualizes signal, and processing automatic temperature compensation.
With automatic dialer, the system can dial 5 groups añarm phones (or pagers) and 4 groups urgent phones (or pagers) to ask for hel. Compatible with DTMF (double tone multi frequency) and pulse dualing.Whth dialing pause function, it can be used for exchange station.
It adopts to leam coding between detectors remote manipulatiors and alarm host.
4 digitals pon can be modified
Whit a hogh-desibel built-in siren, which promptly alarms on the site and guards against theft.
Leaving time (delay defense time) can be set
Wireless remote control, which can realize defense activation, defesedeactivation and firs aid.
6 remote controls and 7 detectors at most can be optioned for the system.
INSTALLATION REQUIREMENTS
1. The infrared detector has the highest sensitivity when a human body moves parallel whit the mirror sufarce and the sensitivity is the lowest when a human body moves vertically against the mirror. As a result, the angle and height against the horizontal sufarce should benoted during installation, which will greatly affect the range of the defense area.the installation height and angle are shown as the following illustration.
2. Stand off from warm or cold sources e,g, warm air or could air outlet air-conditioning outlet, electric, radiators, air colling machines and etc. stand off from the windows
3. There should be no barrier within the defended areaof a detector.
OPERATION
Operation guide
1. Component description
1. Program swich: normaly, the program swich is pressed in, it spring out to program.
2. Activation/desactivation indicator: the indicator will be on when the system is in activation state and it will be off when the system is in deactivation state.
3. DC input: DC 12V-13.8V as backup power
4. AC input:AC15V 50Hz or 60Hz
5. Phone line input
6. Built-in siren output: 4 levels of alarm sound for option.
7. Infared detective sensitivity: it has 3 levels for option move the jumper from h position to L the sensitivity will gradually decrease.
8. Alarm indicator: while power on, the alarm indicator will flash for a 60 seconds for pre-heat. After that it will be off. While the alarmoccurs, the indicator will be on.
9. Socket for backup battery
10. Monitor receiver
11. Power off/on
12. Line in
13. Proof-break it will alarm and dial the urgent phone number or pager when it is open or breaked
2. The sound of cue
a. When the system is powered on, there will be beep, whick indicates the system is normal and in the state of defense activationb. A long beep 15 secound interval shows the system is in low voltage state.
c. During leaving time, yhere will be a long beep every one second. The user should immediately leave the defense area.
3. Operation of the remote control
d. Activation: press key toy desactive and there will be a short beep, and the indicatior will be on
e. Desaactivation: press key to enter andthere will be tow beeps. Indicatioe will be off.
f. Urgent alarm: press key to enter into urgent alarm state, and the system will automatically dial urgent phones for first aid.
4. Alarm-recelving operation
Note: this function should only be suitable for DTMF telecom system
When you receive the alarm phone call you can pick up the handset then hear alarm sound, which will kast...