Tu mama en tanga

E3 FLAHSER installation on Slim PS3
First, we need prepare following item: One PS3 which can downgrade to 3.55 E3 FLASHER Limited version with 8 accessory. (it will include universal screwer)SLIM disassemble tutorial 1: Remove the four hexagon nut under the cover of PS3 bottom.

2: take out nut on the HD, and get out hardisk .

3: Remove the seal, and take off all nuts.

4: open Topcover

5: Take off the nuts beside power, and unplug power cable besides power, take out powe Module.

6: Remove the black nut on the right of 220V power cable and the nuts on the top of BDdriver, please note the big and small size, especially the nut on driver is big, don’t mixed when re-install.

7: Unplug all BD driver data cable

please note there has a data cable under the driver ,becareful unplug it.

8: Unplug the front buttom board before take out BD driver. Please note only disconnect with console, no need take out, because there has cable link to mainboard.

And thencable take out BD DRIVER.

9: Unplug antenna, and remove from mainboard track, no need disconnect metal of antenna, and unplug the front board together with cable.

Finally disconnect picture10: You need take off four white nuts before take out mainboard.(white nut is fixed for HD)

And then can take out mainboard

11: Remove all nuts from metal shade on the back of mainboardTake out Metal shade

SLIM console solder tutorial: following testing point showes the solder range

E3 FLASHER provide soft board special for SLIM console, you can install faster with the testingpoint, no need any diagramme, and 100% safe without any problem.

Solder sequence Solder SBCE point first, and solder SBE to fix soft board. If you can watch all testing point in front it meanscorrect location. And then solder VCC BVCC GND etc, please note those point need heat little more time because of mainboard technology. And then solder other point. Recommend solder posture :

By the...