Wa 8200 - 1N - User Guide

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks
of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation,
transformation, or adaptation without permission from MAXNET.

© 2009 – 2010 MaxnetAll rights reserved.

http://www.maxnet.pe

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and,if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try tocorrect the interference by one or more of the following
measures:


Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.



Consult the dealer or an experienced radio/ TV technician for help.

This device complies withpart 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only
Mobile Configurations. The antennas usedfor this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.

Nationalrestrictions
This device is intended for home and office use in all EU countries (and other countries following
the EU directive 1999/5/EC) without any limitation except for the countries mentioned below:
Country

Restriction

Reason/remark

Bulgaria

None

General authorization required for outdoor use and
public service

France

Outdoor use limited to 10
mW e.i.r.p. withinthe band
2454-2483.5 MHz

Military Radiolocation use. Refarming of the 2.4 GHz
band has been ongoing in recent years to allow current
relaxed regulation. Full implementation planned 2012

Italy

None

If used outside of own premises, general authorization is
required

Luxembourg

None

General authorization required for network and service
supply(not for spectrum)

NorwayImplemented

This subsection does not apply for the geographical area
within a radius of 20 km from the centre of Ny-Ålesund

Russian Federation

None

Only for indoor applications

Note: Please don’t use the product outdoors in France.

CONTENTS
Package Contents .................................................................................................... 1
Conventions...