Addpacc - Configuracion

Multi-Port GSM Gateway
High Performance GSM Gateway Solution

WEB Operation Guide

www.addpac.com

Multi Port GSM Gateway Series
• • • • • AP-GS1500 ( Max GSM Support = 8 ) AP-GS2000 ( Max GSM Support = 12 ) AP-GS2500 ( Max GSM Support = 16 ) AP-GS3000 ( Max GSM Support = 32 ) AP-GS5000 ( Max GSM Support = 80 )

www.addpac.com

2

Contents
1. 2. 3. 4. 5. 6. 7. 8. 9. WEBConnection Network Setup GSM Setup VoIP Setup Callback Service LCR SMS Advanced Service Monitoring

www.addpac.com

3

WEB Connection

1. Web Connection via Console Port 2. Web Connection via LAN 1 Port

www.addpac.com

4

WEB Connection
1. Web Connection via Console Port

1.

Serial port
2. 3.

Connect to Gateway via console port to enter IP address in order to set Interface 0/0Input IP address of interface 0/0 using below command Connect to the IP address via web after saving

Baud rate 9600 No parity 1 stop bit No flow control

login ID/Password : root/router
Router> enable Router# configure terminal Router(config)# interface FastEthernet 0/0 Router(config-if)# ip address Router(config-if)# exit Router(config)# ip route 0.0.0.0 0.0.0.0 Router(config)# writeProceed with write? [confirm]y => Enter the enable mode => Enter the configuration mode => Ex) ip address 172.17.109.1 255.255.0.0 => Ex) ip route 0.0.0.0 0.0.0.0 172.17.1.1 => saving

www.addpac.com

5

WEB Connection
2. Connection Web via LAN 1 Port

Cross Cable

LAN 1 Default IP IP Address : 192.168.10.1 Subnet mask : 255.255.255.0

LAN 1
1. 2. It is the way to connect to GSM Gatewayvia LAN 1 port The factory default of LAN 1 port - IP Address : 192.168.10.1 - Subnet mask : 255.255.255.0 After set PC with same IP address subnet, connect to GSM Gateway - Connect PC to AP-GS3000 using Cross UTP-Cable. You may use Ethernet switch with normal UTP-cable - Enter IP address 192.168.10.1 on your web browser

3.

www.addpac.com

6

WEB Connection
1. The screen of Webconnection
• The Shown log-in screen is connection to Web page. Please enter the below log-in information ID : root Password : router

www.addpac.com

7

Network Setup
1. WAN Setup Screen -1
① ① WAN Setup (LAN0) -Hostname : Enter the device name of Gateway -Static IP -PPPoE(ADSL) -DHCP -VLAN -NAT / Bridge * Please make sure to press the apply button for saving

Click

www.addpac.com

8Network Setup
1. WAN Setup Screen -2
② ② WAN Setup (LAN0) -PPTP setup * Please make sure to press the apply button for saving

Click

www.addpac.com

9

Network Setup
2. LAN Setup Screen
① ① LAN Setup (LAN1) -None : Use default IP address 192.168.10.1. -IP share : Use it by sharing WAN IP. -Static : Use it by setting up IP address.

Click

www.addpac.com

10

GSM Setup1. 2. 3. 4.

GSM Dial Plan / Prefix E1 Extension FXS Extension GSM Extension

www.addpac.com

11

GSM Setup
AddPac Digit Structure
※Digit Structure※ 9T : All number started with 9 as the first digit 4.. : Three digit number started with 4 as the first digit [2-9]T : All number started with 2 to 9 as the first digit 00[127]T : All number started with 001, 002, 007 as the first digit

**T : Accept all number entered within Inter Digit Time (Default IDT : 3sec) ** Dot(.) : One dot(.) means one digit ** [ ] : The range of number

※Rule tranfer※ - Digit pattern : 025683848 / Digits to insert : 82 / Number of digits to delete : 1 8225683848 - Digit pattern : 00[127]T / Digits to insert : 123 / Number of digits to delete : 2 123[127]T - Digit pattern : [2-9]4... / Digits to insert: 823848 / Number of digits to delete : 3 823848..

www.addpac.com

12

GSM Setup > Port Information

Port information: You may check the modules in each slot.

www.addpac.com

13

GSM Setup > Dial Plan
1. GSM Dial Plan / Prefix -1
①

②

Dial Plan / Prefix : Setting for making outgoing call to GSM Networks using E1(FXS) or VoIP ① Plan Table : Outgoing call to GSM network...