So you want to be a criminal. Well, if you want to be like James Bond and open a lock in fifteen seconds, then go to Hollywood, because that is the only place you are ever going to do it. Evenexperienced locksmiths can spend five to ten minutes on a lock if they are unlucky. If you are wanting extremely quick access, look elsewhere. The following instructions will pertain mostly to the "lock inknob" type lock, since it is the easiest to pick.
First of all, you need a pick set. If you know a locksmith, get him to make you a set. This will be the best possible set for you to use. If youfind a locksmith unwilling to supply a set, don't give up hope. It is possible to make your own, if you have access to a grinder (you can use a file, but it takes forever).
The thing you need is anallen wrench set (very small). These should be small enough to fit into the keyhole slot. Now, bend the long end of the allen wrench at a slight angle (not 90°). Now, take your pick to a grinder or afile, and smooth the end until it is rounded so it won't hang inside the lock. Test your tool out on doorknobs at your house to see if it will slide in and out smoothly. Now, this is where thescrewdriver comes in. It must be small enough for it and your pick to be used in the same lock at the same time, one above the other. In the coming instructions, please refer to this chart of the interiorof a lock:
| | | | | | / E
| | | | \ Y [|] Upper tumbler pin
^ ^/ H [^] Lower tumbler pin
^ ^ ^ ^ ^ ^ \ O [-] Cylinder wall
/ L (This is a greatly simplified\ E drawing)
The object is to press the pin up so that the space between the upper pin and the lower pin is level with the cylinder wall. Now, if you...
Leer documento completo
Regístrate para leer el documento completo.