Redes 1.3.1

PT Activity 1.3.1: Review of Concepts from Exploration 1
Topology Diagram

NOTE TO USER: This activity is a variation of lab 1.3.1. This Packet Tracer Activity is not a companion for the abovenamed lab. The instructions for completing this activity are found within this activity.

Learning Objectives
• • • • • Design a logical LAN topology. Configure the physical topology. Configure thelogical topology. Verify network connectivity. Verify passwords.

Introduction
In this activity, you will design and configure a small routed network and verify connectivity across multiple networkdevices. This requires creating and assigning two subnetwork blocks, connecting hosts and network devices, and configuring host computers and one Cisco router for basic network connectivity. Switch1has a default configuration and does not require additional configuration. You will use common commands to test and document the network. The zero subnet is used.

Task 1: Design a Logical LANTopology
Step 1. Design an IP addressing scheme. Given the IP address block of 192.168.7.0 /24, design an IP addressing scheme that satisfies the following requirements: Subnet Subnet A Number of Hosts 110Page 1 of 4

All contents are Copyright © 2007-2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.

CCNA Exploration LAN Switching and Wireless: LAN DesignPT Activity 1.3.1: Review of Concepts from Exploration 1

Subnet Subnet B

Number of Hosts 54

Subnet zero is used. No subnet calculators may be used. Create the smallest possible subnets thatsatisfy the requirements for hosts. Assign the first usable subnet to Subnet A. Host computers will use the first IP address in the subnet. The network router will use the last IP address in thesubnet. Step 2. Write down the IP address information for each device. Before proceeding, verify your IP addresses with the instructor.

Task 2: Configure the Physical Topology
Step 1. Cable the...