Cambio De Voltaje Y Frecuencia En Un Equipo Cummins

How to change the voltage & frequency of the Power Pack

 Open the panel of the Power Command.

 To get down the speed of the engine (RPM) andfrequency, turn the precision screw of the engine governor inside the panel counterclockwise (about two and a half turns).

1

 Go to the control panel andpress any button to start the communication between the engine and the Power Command.  Press both arrows for a few seconds at the same time.

 SelectOption one (1, Setup Menu)

2

 The system will ask for a password, wish is 574, (you can navigate around the digits and change them with the buttons +,- and the arrow), to go to the next screen, press the arrow.

 Select the option one (1, Gen-set Service).

3

 Select the option one (1,Gen-set).

 Select the button “ADJUST”.

4

 Now you can change the voltage and frequency configuration navigating with the buttons +, - and the arrow.



 Press the button “SAVE”.

5

 Press, in the Power Command Control the button Previous Menu several times, until the main screen shows up.

 Turn on the generating group (The frequency will not be the desire one yet).  Pres any of the arrows until you get to the screen who shows up thefrequency and speed, (RPM).



 Now, whits the engine on and very carefully, continues turning the precision screw of the engine governor until you getthe desire frequency and speed.  For a 50 Hz frequency, you will need about 1500 RPM.  For a 60 Hz frequency, you will need about 1800 RPM.

6