Catia V5 Ejercicios (En Inglés)
Part Design Exercicios
TRV5PD
TRV5PD (Exercicios) – Página 2
Rua Cotoxó, 411. Sala 44. CEP 05121-000. São Paulo. SP,
Tel: XX-11-3675-2799. Fax: XX-11-3676-1363
www.nvsistemas.com.br
Maiores Informações:
NV Sistemas Ltda.
Rua Cotoxó, 611 - Sala 44.
05021-000. São Paulo. SP.
Tel: (0XX) 11 3675-2799
Fax: (0XX) 11 3676-1363
www.nvsistemas.com.br
Esta publicação é parteintegrante do conjunto de treinamentos oferecidos
pela NV Sistemas e não pode ser vendida separadamente.
Julgamos que as informações contidas nesta publicação sejam exatas,
entretanto, a NV Sistemas não assume nenhuma responsibilidade pelo seu
uso. As informações estão sujeitas a alterações sem aviso prévio e não devem
ser interpretadas como um compromisso da NV Sistemas.
CATIA é marcaregistrada da Dassault Systèmes S. A.
TRV5PD (Exercicios) – Página 3
Rua Cotoxó, 411. Sala 44. CEP 05121-000. São Paulo. SP,
Tel: XX-11-3675-2799. Fax: XX-11-3676-1363
www.nvsistemas.com.br
Table of Contents
Piston ..............................................................................................................................5
Creating the MainPad..................................................................................................5
Creating the Symmetrical Cut-out.................................................................................7
Creating the Cylindrical Boss......................................................................................13
Creating Pockets........................................................................................................14
Creating a Through Hole ............................................................................................17
Creating Fillets............................................................................................................19
Changing the color.....................................................................................................25
Angle Bracket ................................................................................................................27
Setting Part Design Parameters .................................................................................28
Defining the Pads for the Bracket ...............................................................................28Defining the Pilot Holes and the Angular Pads for the Bracket...................................32
Defining the Clevis Through Hole and Fillets..............................................................36
Building the Hinge .........................................................................................................37
Car JackSupport...........................................................................................................48
Creating Profiles and Pads.........................................................................................50
Creating Draft Angles .................................................................................................53
Creating Edge Fillets..................................................................................................55
Creating Additional Profiles and Pads ........................................................................57
Creating Edge Fillets for the Additional Pads .............................................................60
Creating Holes............................................................................................................62Creating Grooves .......................................................................................................83
Creating a Chamfer. ...................................................................................................86
Creating Pockets. .......................................................................................................88
Creating Edge Fillets....
Regístrate para leer el documento completo.