Controllogix Analog Io Modules 1756-If16,- If6Cis, -If6I, -If8, -Ir6I, -It6I, -It6I2, -Of4, -Of6Ci, -Of6

ControlLogix Analog I/O Modules
1756-IF16,- IF6CIS, -IF6I, -IF8, -IR6I, -IT6I, -IT6I2, -OF4, -OF6CI, -OF6VI, -OF8

User Manual

Important User Information

Because of the variety of uses for the products described in this publication, those responsible for the application and use of these products must satisfy themselves that all necessary steps have been taken to assure that eachapplication and use meets all performance and safety requirements, including any applicable laws, regulations, codes and standards. In no event will Rockwell Automation™ be responsible or liable for indirect or consequential damage resulting from the use or application of these products. Any illustrations, charts, sample programs, and layout examples shown in this publication are intended solely forpurposes of example. Since there are many variables and requirements associated with any particular installation, Rockwell Automation does not assume responsibility or liability (to include intellectual property liability) for actual use based upon the examples shown in this publication. Allen-Bradley™ publication SGI-1.1, Safety Guidelines for the Application, Installation and Maintenance ofSolid-State Control (available from your local Rockwell Automation office), describes some important differences between solid-state equipment and electromechanical devices that should be taken into consideration when applying products such as those described in this publication. Reproduction of the contents of this copyrighted publication, in whole or part, without written permission of RockwellAutomation, is prohibited. Throughout this publication, notes may be used to make you aware of safety considerations. The following annotations and their accompanying statements help you to identify a potential hazard, avoid a potential hazard, and recognize the consequences of a potential hazard:

WARNING

!
ATTENTION

Identifies information about practices or circumstances that can cause anexplosion in a hazardous environment, which may lead to personal injury or death, property damage, or economic loss.

!
IMPORTANT

Identifies information about practices or circumstances that can lead to personal injury or death, property damage, or economic loss.

Identifies information that is critical for successful application and understanding of the product.

Allen-Bradley, ControlLogixand Rockwell Automation are registered trademarks of Rockwell Automation, Inc. RSLogix and RSNetWorx are trademarks of Rockwell Automation, Inc. ControlNet is a trademark of ControlNet International, Ltd. EtherNet/IP is a trademark under license of the Open DeviceNet Vendor Association.

Summary of Changes

Introduction

This release of this document contains updated information. Changesare designated by change bars in margin, as shown.

New and Revised Information

Table Summary of Changes.1 lists the new and revised information included in this release of the ControlLogix digital I/O modules user manual.
Table Summary of Changes.1 New and Revised Information In this section: Chapter 2 Chapter 3 Module-specific chapters (i.e. Chapter 4 through Chapter 8) Chapter 5 Chapter 6This information changed or was added: Triggering Event Tasks

· Electronic Keying · 1756-IF6I module count information in integer mode
Module block diagrams and input/output circuit diagrams

Full description of ControlLogix Sourcing Current Loop Input Module (1756-IF6CIS)

· Full description of ControlLogix Thermocouple Input Module (1756-IT6I2) · Wire Off Detection with the 1756-IR6Imodule · Specifications for 1756-IF6CIS module · Specifications for 1756-IT6I2 module · Updated Open Circuit Detection specification for the 1756-IR6I module

Appendix A

Appendix C

Differences when using message instructions in RSLogix™ 5000, v 9 or earlier versus using RSLogix 5000, v10 or greater. Additional specification information After Appendix C

Appendix E Glossary

Other changes...