Fife

CDP-01 Additional Instruction Manual
For Uncoiler Application With Sensor Seek And Auto Permissive

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

NOTE

These additional instructions explain the special features of the system delivered to the customer. They are intended for being used in conjunction with the CDP-01 ReferenceManual. The CDP-01 Reference Manual applies except as noted to the contrary in these instructions.

Copyright: All rights reserved. Any reproduction of this Additional Instruction Manual, in any form, in whole or in part, requires the prior written consent of FIFE. The information given in this Additional Instruction Manual is subject to change without notice. We have compiled this AdditionalInstruction Manual with the greatest possible care and attention: however, the possibility of error can not be completely excluded. FIFE accepts no legal liability for incorrect information given and the consequences arising therefrom.  2000 FIFE Corporation, P.O. Box 26508, Oklahoma City, OK 73126, U.S.A. FIFE GmbH,Postfach 1240, D-65762 Kelkheim/Ts., Germany

DATE: March 6, 2000

CDP-01

Fig.Sheet 1-814

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

CONENTS

I

Table of contents GENERAL INTRODUCTION 1

APPLICATION DESCRIPTION ............................................................................................. 1-1 SOFTWARE PART NUMBERS............................................................................................. 1-1 CONNECTING THE SYSTEMCOMPONENTS.................................................................... 1-1

OVERVIEW OF FUNCTION

2

OPERATOR CONTROL OPTIONS....................................................................................... 2-1 SPECIAL FEATURES OF EXTERNAL CONTROL............................................................... 2-1 INPUT MATRIX - EXTERNAL CONTROL............................................................................ 2-2 EXPLANATION OF THE OPERATING MODES................................................................... 2-3 START UP / GUIDING SENSOR CALIBRATION ................................................................. 2-6 START UP / SENSOR DRIVE POLARITY............................................................................ 2-7 START UP / MANDREL DRIVE POLARITY......................................................................... 2-8

TROUBLESHOOTING

3

FAULT DIAGNOSIS - FAULT RECTIFICATION ................................................................... 3-1

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

CONENTS

I

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

SUPPLEMENTARY OPERATING MANUAL

1 1-1

GENERALINTRODUCTION

Application description
Application is an Uncoiler. External control is required. When placed in automatic mode, the sensor seeks the web edge. The sensor follows the web edge as long as the Auto Permissive input is high. Once the Auto Permissive input goes low, the sensor positioner is placed in Manual mode and the mandrel is placed in Automatic mode. A CDP-01-MH is used for thisapplication. The sensor positioner is connected to drive 1 and the mandrel is connected to drive 2.

Software part numbers
The software part numbers are located on the side of the CDP-01 housing. They include the Matrix Setup no. (MS) , State Machine no. (SM) and firmware version ( Dx ).

CDP version: CDP-01-MH

D1:5650xx-02x D2:5650xx-02x D3:5650xx-02x

MS: 100059-02x SM: 100060-02x FIFE USAPlease quote these details with all inquiries.

Connecting the system components
The system components are to be connected according to the Cable Connection Diagram contained in the documentation.

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

SUPPLEMENTARY OPERATING MANUAL

1 1-2

DATE: March 6, 2000

CDP-01

Fig. Sheet 1-814

SUPPLEMENTARY OPERATING MANUAL

2 2-1...