Ieee Abstract

IEEE-NANO 2012 Microsoft Word Template
Chennupati Jagadish1, Chris Bailey2, and Parviz Famouri3
1Department of Electronic Materials Engineering, Australian National University, Canberra, ACT 0200, Australia
2School of Computing & Mathematical Sciences, University of Greenwich, London SE10 9LS, UK
3Lane Department of Computer Science & Electrical Engineering, West Virginia University,Morgantown, WV 26506-6070
Email: cxj109@physics.anu.edu.au, C.Bailey@gre.ac.uk, parviz.famouri@mail.wvu.edu


Abstract — These instructions give you guidelines for preparing papers and 2-page abstracts for IEEE conferences. Use this document as a template if you are using Microsoft Word 6.0 or later. Otherwise, use this document as an instruction set. Please use this document as a “template” toprepare your manuscript. For submission guidelines, follow instructions on the paper submission system as well as the Conference website. The abstract paper should be a summary of your work (including abstract, short introduction and some results). Since the abstract is limited to 2 pages, you may include the most important result in the paper abstract. The abstract can then serve as the templatefor your paper.

Index Terms - List key index terms here. No mare than 5.

I. INTRODUCTION
Your goal is to simulate the usual appearance of papers in IEEE conference proceedings. For items not addressed in these instructions, please refer to the last issue of your conference's proceedings for reference or ask the conference Publications Chair for instructions.

A. Preparing Your Paper
1)Paper Size: Prepare your paper in full-size format on US letter size paper (8.5 by 11 inches).
2) The font type sizes are given in points, same as in the MS Word font size points. Times New Roman is the preferred font.
3) Paper Margins: Paper margins on the US letter size paper are set as follows: top = 0.75 inches, bottom = 0.75 inch, side = 0.75 inches. Each column measures 3.4 inches wide,with a 0.2-inch gap between the two columns.
4) Paper Styles: Left- and right-justify the columns. On the last page of your paper, adjust the lengths of the columns so that they are equal. Use automatic hyphenation and check spelling and grammar. Use high resolution (300dpi or above) figures, plots, drawings and photos for best printing result.

B. Preparing Your PDF Paper for IEEE Xplore©Detailed instructions on how to prepare PDF files of your papers for IEEE Xplore© can be found at
http://www.ieee.org/pubs/confpubcenter
PDF job setting files for Acrobat versions 4, 5 and 6 can be found for downloading from the above webpage as well. The instructions for preparing PDF papers for IEEE Xplore© must be strictly followed.

II. HELPFUL HINTS
A. Figures and Tables
Try toposition figures and tables at the tops and bottoms of columns and avoid placing them in the middle of columns. Large figures and tables may span across both columns. Figure captions should be centered below the figures; table captions should be centered above. Avoid placing figures and tables before their first mention in the text. Use the abbreviation “Fig. #,” even at the beginning of a sentence.Figure axis labels are often a source of confusion. Use words rather than symbols. For example, as shown in Fig. 1, write “Magnetization,” or “Magnetization (M)” not just “M.” Put units in parentheses. Do not label axes only with units. In the example, write “Magnetization (A/m)” or “Magnetization (A ∙ m-1).” Do not label axes with a ratio of quantities and units. For example, write“Temperature (K),” not “Temperature/K.”
Multipliers can be very confusing. Write “Magnetization (kA/m)” or “Magnetization (103 A/m).” Figure labels should be legible, at 8-point type.


Applied Field (103 A/m)
Fig. 1 Magnetization as a function of applied field.
Note how the caption is centered in the column.
B. References
Number citations consecutively in square brackets [1]. Punctuation...