Manual Pegasus Box

Pegasus Software User Manual v1.0

© 2011 GsmServer Team

Table of Contents

Pegasus Software Overview ................................................................................................3 Service Mode Explanation ...................................................................................................5 Pegasus Unlock Procedure Tutorial.....................................................................................9 Creating a Backup Copy.....................................................................................................15 Flash Procedure ................................................................................................................20 Rebuild IMEI......................................................................................................................27

[2]

Pegasus Software Overview

“MANUFACTURER” button is used to select a phone manufacturer. At this moment only Samsung is supported.

“PHONE MODEL” drop-down list is used for phone model selection. Attention! Always select phone model according to the firmware version inside your phone. In most cases the only way to determine B, D etc.modifications is to check phone firmware. To do so, please dial *#1234# on the phone keypad.

“CREATE MODULE” button is used to create Pegasus software module according to the chosen phone manufacturer. Pegasus software supports simultaneous operation with [3]

as many COM ports as you have boxes or phones in USB mode connected to your PC. Each module allows to service one phone at a time.“TAKE SCREENSHOT” button is used to make screenshots of Pegasus software current status. Screenshots are saved in “Screenshots” folder, in the Pegasus installation folder. Files are automatically named “Screenshot dd.mm.yyyy. hh-mm-ss.jpg”. You may use this button to save log information and send it to Support Team if you encounter some technical problems.

“Exit” button closes all opened modulesand Pegasus software. Warning! All operations will be cancelled immediately! Make sure that no phone is being flashed at this moment!

[4]

Service Mode Explanation

“HELP” button is used to open Help file for the Pegasus software. “COPY TO CLIPBOARD” Copy all available info from the log file to Windows clipboard. It allows to copy all required information to any *.txt flash file ormessenger window. “SAVE LOG TO FILE” button is used to save operation logs of the Pegasus software to files in *.txt file format. Log files are saved in “LOGS” folder, in the Pegasus installation folder. Files are automatically named “Brandname dd.mm.yyyy. hh_mm_ss.log”. You may use this button to save log information and send it to Support Team if you encounter some technical problems. “CLEAR LOG” Eraseall the data from the log window.

[5]

“CLOSE MODULE WINDOW” Closes active module window. Please notice, all active procedures will be terminated if the module get closed. “COM PORT” drop-down list is used to select operation port. Pegasus software communicates through any interface able to create virtual COM port on your PC. Native COM1 and USB operation is supported as well. “BAUDRATE”drop-down menu is used to select operation speed. The higher speed is selected – the faster will the flashing procedure be. “IMEI” Reads IMEI number of the phone. “SN” Reads serial number of the handset

“CONNECT TO PHONE” button is used to start boot sequence and put your phone into appropriate mode for servicing operations.

“UNOCK PHONE” button used to perform unlock procedure of the connectedphone. Please notice that COM port and phone model suppose to match connected handset.

“FACTORY RESET” Resets phone settings to the default one, settings that get set to the phone at the factory.

“REPAIR EMPTY BOARD” button is used to repair “illegal trial” error, IMEI 00000000000000 that can’t be repaired in usual way etc. You should type handset serial number to input field.

You...