Medicion

g

GEH-6421B (Supersedes GEH-6421A)

GE Industrial Systems

System Guide
for the SPEEDTRONIC™ Mark VI Turbine Control

Publication: Issued:

GEH-6421B 2000-11-30

System Guide
for the SPEEDTRONIC™ Mark VI Turbine Control

© 2000 General Electric Company, USA. All rights reserved. Printed in the United States of America.

These instructions do not purport to cover all detailsor variations in equipment, nor to provide every possible contingency to be met during installation, operation, and maintenance. If further information is desired or if particular problems arise that are not covered sufficiently for the purchaser’s purpose, the matter should be referred to GE Industrial Systems, Salem, Virginia, USA. This document contains proprietary information of GeneralElectric Company, USA and is furnished to its customer solely to assist that customer in the installation, testing, operation, and/or maintenance of the equipment described. This document shall not be reproduced in whole or in part nor shall its contents be disclosed to any third party without the written approval of GE Industrial Systems.

ARCNET is a registered trademark of Datapoint Corporation.CIMPLICITY is a trademark of GE Fanuc Automation North America, Inc. Ethernet is a trademark of Xerox Corporation. Genius is a registered trademark of GE Fanuc Automation North America, Inc. IBM is a registered trademark of International Business Machines Corporation. Intel is a registered trademark of Intel Corporation. Modbus is a registered trademark of Modicon. PC is a registered trademark ofInternational Business Machines Corporation. Pentium is a registered trademark of Intel Corporation. PI-ProcessBook is a registered trademark of OSI Software Inc. PI-Data Archive and PI-DataLink are registered trademarks of OSI Software Inc. Proximitor, Velomitor, and KeyPhasor are registered trademarks of Bently Nevada. QNX is a registered trademark of QNX Software Systems, LTD. Series 90 is atrademark of GE Fanuc Automation North America, Inc. SPEEDTRONIC is a trademark of General Electric Company, USA. Windows is a registered trademark of Microsoft Corporation. Windows NT is a registered trademark of Microsoft Corporation.

Safety Symbol Legend

Indicates a procedure or condition that, if not strictly observed, could result in personal injury or death.

Indicates a procedure orcondition that, if not strictly observed, could result in damage to or destruction of equipment.

Indicates a procedure or condition that should be strictly followed in order to optimize these applications.

Note Indicates an essential or important procedure, condition, or statement.

!
Warning

This equipment contains a potential hazard of electric shock or burn. Only personnel who areadequately trained and thoroughly familiar with the equipment and the instructions should install, operate, or maintain this equipment. To prevent personal injury or equipment damage caused by equipment malfunction, only adequately trained personnel should modify any programmable machine.

!
Caution

The example and setup screens in this manual do not reflect the actual applicationconfigurations. Be sure to follow the correct setup procedures for your application.

Locations
O R D 1 P OS E EX 2 Supplied by Others Remotely Mounted Door Mounted

Drawing Symbols
Purchaser's Equipment Bus Aux Compt Device Generator Compt Device
G

Mounted on Door 1, 2, and so on Panel Mounted Mounted in Main Operator Station Equipment Exists in place EX2000 Exciter Generator Control Panel TurbineControl

Generator Terminal Enclosure Packaged Electrical Cont. CTR (PEEC) PEECC MCC

SS LCI ISO

Static Starter Load Commutated Inverter Isolation Transformer Generator Excitation Compartment

Devices
J1

Cable Plug Connector Jumper Relay Coil Solenoid Coil Flame Detector

Case Ground Ground Bus Signal Ground Contact Actually Shown Elsewhere Customer Connection

Conventions...