Programacion Esc

Boat ESC B70A/B125A/B200A ESC Important Note: Some of these ESCs are without BEC. You need extra power
source for your receiver. You can use a UBEC / voltage regulator, or extra batteries as thepower source for your receiver. If you hear the music tone repeat again and again for more than 3 times, you may need to check your power source to the receiver.

·Phrases 1 Enter programming Mode1. 2.

3.

Connect your motor and receiver to the speed controller, but do not connect the battery yet. Turn on your transmitter and move the throttle stick to the full throttle position (full up).Please Note: Most Futaba transmitters have the throttle channel reversed by default. Connect your battery and the controller will initialize with a musical tone.

·Phrases 2 Programming

After 3seconds, the motor will start beeping a sequence of tones – a musical tone followed by one or more beeps. Each sequence represents a parameter that you can program and is repeated 3 times. Theparameters are: Music Tone + 1 Beep Music Tone + 2 Beeps Music Tone + 3 Beeps Music Tone + 4 Beeps Music Tone + 5 Beeps Options 1. Cell Type and No. of Cells Options 2. Acceleration Options 3. ReverseOptions 4. Timing Mode Options 5. PWM setting

♪— ♪— — ♪— — — ♪— — — — ♪— — — — —

Step 1. Starting, Enter Sub-optins. When you hear the sequence for the parameter you wish to program, move the throttlestick to the Center Position to Enter Sub-options. The controller will then start beeping a Morse code sequence of short and long beeps representing the possible options you may choose for theselected parameter. See table 2 for a list of all programmable options. Each option sequence is repeated 3 times. Step 2. Select and save, the select the option, move the throttle stick back to theFull-up-position., When you hear the sequence for the option you wish to select. The controller will then save the selected option, and sound a long beep as a confirmation. It then goes back to the...