Transmisor Inalambrico

EN1210 EchoStream® Single Input Universal Transmitter
Installation Instructions - 05177E 1 Overview
The EN1210 is a universal security transmitter.

1. Place a selection jumper on the appropriate frequency band selection pins. • Place the jumper on the right two pins, marked NZ, to set the frequency range to 921-928 MHz for New Zealand. • Place the jumper on the left two pins, marked AU, toset the frequency range to 915-928 MHz for Australia. • Leave the jumper off the pins to set the frequency range to 902-928 MHz for North America. 2. Press the Reset button to complete configuration. Caution: When pressing the Reset button, make sure you don’t also touch the frequency band selection pins. Touching the frequency band selection pins while pressing the Reset button can inadvertentlyset the EN1210 to the wrong frequency band.

6 Television and Radio Interference
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.

1.1 Inovonics Wireless Contact InformationIf you have any problems with this procedure, contact Inovonics Wireless technical services: • E-mail: support@inovonics.com • Phone: (800) 782-2709

3 Select Input Type
The N/O-N/C selection pins allow the choice of a normally open or normally closed state for the contact circuit wired to the input terminal. The transmitter is shipped set for normally closed, with no selection jumper on theN/O selections pins. 1. Place a selection jumper on the selection pins to select normally open; remove the selection jumper from the selection pins to select normally closed. 2. Press the Reset button to complete configuration.

1.2 EN1210 Components
A B C

7 FCC Part 15 and Industry Canada Compliance
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSSstandard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditionssuivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

4 Register the EN1210
Transmitters must be registered with the system in order to be monitored and supervised. Transmitters send a check-in message every three minutes. Eachtransmitter has a unique factory-programmed identification number. Refer to the receiver installation instructions for details on registering a transmitter. 1. When prompted by the receiver to reset transmitter, press the Reset button. 2. Replace the cover. 3. Test the EN1210 by activating each of the conditions and ensuring an appropriate response.

D
A Frequency band selection pins C Antenna...