Como Armar Una Bicicleta En Ingles

INDEX

1: BASIC MAINTENANCE
1.1: WASH AND LUBRICATION

2: BRAKES
2.1: UPGRADE YOUR BRAKES

3: RIMS
3.1: CHANGE OF RIMS

BASIC MAINTENANCE

WASH AND LUBRICATION:

1: The tools we useare:
Brush, container or can to pour the liquid degreaser, a chain cleaning sponge, a bucket of water, a boat and a boat dishwasher solid fat.

2: Hanging the machine and secured, with wheels removedif possible, start by cleaning the areas most remove dirt hill because any dust or mud sticks "thank you" to the oil that lubricates the transmission. With the brush wet with degreaser rub well therear derailleur and especially Rodanas (ruletitas) until no oil rasto pasty.

3: Here we go with the front derailleur, rubbing well with the brush and change moviendo el controls to let the degreaserfor areas that are barely visible. Followed make a past (or more) for the dishes, another area hard to remove dirt, preventing it fro m degreaser inside the bottom brack

4: The next step is toclean the brake pads and they collect enough dirt, for which we must give a good dab on both.

5: The solid fat use it to grease the brake cables and less frequent changes and lubrication, the seatpost, the power and cintre..

BRAKES

UPGRADE YOUR BRAKES:

1: After preparing the tools, we check if we can still use the shoes that we have in our brakes for the case to be worn replace withnew ones.

2: The cover has to be as short as possible without the curve that makes it go forced.

3: Before cutting the casing rear brake lever tensioner right do the same as in the previous step,turn the handlebar to the top right and cut the sleeve so that it can be shorter but in a way that does not impede turn the handlebar.

4: We cut it short also can cover the small piece of wirecarrying the rear between the horizontal tube and rear triangle pods. When you finish cutting the pieces of cover, check that the wire carrying the same does not obstruct the exit of the cable, cut the...