Bombas sumergibles franklin electric

4” and 6” SUBMERSIBLE PUMPS OWNER'S MANUAL
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury:
D A N G E R warns about hazards that will cause serious personal injury, death or major property damage if ignored. W A R N I N Gwarns about hazards that can cause serious personal injury, death or major property damage if ignored. C A U T I O N warns about hazards that will or can cause minor personal injury or major property damage if ignored.

The label NOTICE indicates special instructions, which are important but not related to hazards.

WA R N I N G

Carefully read and follow all safety instructions in this manualand on pump. Keep safety labels in good condition. Replace missing or damaged safety labels.
WARNING

Hazardous voltage. Can shock, burn, or cause death.

BEFORE INSTALLING PUMP, BE SURE TO READ THIS OWNER’S MANUAL CAREFULLY.
C A U T I O N Fill pump with water before starting or pump will be damaged. The motor on this pump is guaranteed by the manufacturer. In event of failure it must bereturned to an authorized service station for repairs. Motor warranty is void if repairs are not made by an authorized repair station.

Ground pump before connecting to power supply. Disconnect power before working on pump, motor or tank.

Wire motor for correct voltage. See “Electrical” section of this manual and motor nameplate.

WARNING

Ground motor before connecting to

power supply.W A R N I N G Meet National Electrical Code, Canadian Electrical Code, and local codes for all wiring. W A R N I N G Follow wiring instructions in this manual when connecting motor to power lines.

INSPECT THE SHIPMENT
Examine the pump when it is received to be sure there has been no damage in shipping. Should any be evident, report it immediately to the dealer from whom the pump was purchased.Please check the pump package to see that it includes pump, motor, and motor leads (if your pump purchase includes a motor).

WARNING

INSTALLATION RECORDS
It is good idea to keep an accurate record of your installation. Be sure to record the data below: Purchased From: Date of Installation: Pump Model No.* Pump Date Code* Well Inside Dia.(in/mm): Depth of Well(ft/m): Depth of Water(ft/m):Pump Setting(ft/m): Drop Pipe Size: Wire Size(pump to control box): Wire Size(control box to power source): Horizontal Offset(between well & house): Make of Motor* Amps HP Volts Ph

IMPORTANT INFORMATION FOR INSTALLERS OF THIS EQUIPMENT!
THIS EQUIPMENT IS INTENDED FOR INSTALLATION BY TECHNICALLY QUALIFIED PERSONNEL. FAILURE TO INSTALL IT IN COMPLIANCE WITH NATIONAL AND LOCAL ELECTRICAL CODES,AND WITH FRANKLIN ELECTRIC RECOMMENDATIONS, MAY RESULT IN ELECTRICAL SHOCK OR FIRE HAZARD, UNSATISFACTORY PERFORMANCE, AND EQUIPMENT FAILURE. FRANKLIN INSTALLATION INFORMATION IS AVAILABLE FROM PUMP MANUFACTURERS AND DISTRIBUTORS, AND DIRECTLY FROM FRANKLIN ELECTRIC. CALL FRANKLIN TOLL FREE 800-348-2420 FOR INFORMATION. RETAIN THIS INFORMATION SHEET WITH THE EQUIPMENT FOR FUTURE REFERENCE.WARNING
SERIOUS OR FATAL ELECTRICAL SHOCK MAY RESULT FROM FAILURE TO CONNECT THE MOTOR, CONTROL ENCLOSURES, METAL PLUMBING, AND ALL OTHER METAL NEAR THE MOTOR OR CABLE, TO THE POWER SUPPLY GROUND TERMINAL USING WIRE NO SMALLER THAN MOTOR CABLE WIRES. TO REDUCE RISK OF ELECTRICAL SHOCK, DISCONNECT POWER BEFORE WORKING ON OR AROUND THE WATER SYSTEM. DO NOT USE MOTOR IN SWIMMING AREAS. Make of ControlBox HP Power Supply Volts Pressure Switch (PSI) Cut-in Cut-out HZ Volts

* This Information is on your pump or motor tag. It will help us identify your pump in case of later inquiries.

TEST RUNNING
If test running pump before installation: 1. Insure that the power supply corresponds with that shown on the nameplate of the motor and control box. (if required). 2. Install pump and components...