Conexion Electrica Mz2

BACK TO CHAPTER INDEX

MAZDA 2 WORKSHOP REPAIR MANUAL 2007

TO MODEL INDEX

SECURITY AND LOCKS
THEFT-DETERRENT CONTROL MODULE INSPECTION
id091400820900

1. Remove the following parts: (1)Front scuff plate (driver's side) (See 09-17-32 FRONT SCUFF PLATE REMOVAL/INSTALLATION.) (2) Front side trim (driver's side) (See 09-17-31 FRONT SIDE TRIM REMOVAL/INSTALLATION.) (3) Side panel (See09-17-17 SIDE PANEL REMOVAL/INSTALLATION.) (4) Shift lever knob (See 05-16-2 MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [F35M-R].) (5) Side wall (See 09-17-19 SIDE WALL REMOVAL/INSTALLATION.)(6) Front console component (See 09-17-20 FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION.) (7) Bonnet release lever (See 09-14-17 BONNET LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.) (8) Lower panel(See 09-17-15 LOWER PANEL REMOVAL/INSTALLATION.) 2. Measure the voltage according to the terminal voltage table. • If the voltages cannot be verified as indicated in the terminal voltage table, inspectthe parts under “Inspection item(s)”. — If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the theft-deterrentcontrol module. Terminal Voltage Table (Reference)
THEFT-DETERRENT CONTROL MODULE

W X

U V

S T

Q R

O P

M N

K K

I J

G H

E

C

am2zzw0000059

Termin al C

Signal name •Intruder sensor signal • Theft-deterrent siren signal Start knob (push switch)

Connected to • Intruder sensor • Theft-deterrent siren

Measurement condition

Voltage (V)

Inspection item(s)Terminal used for communication therefore determination based on terminal voltage inspection not possible. B+ 1.0 or less B+ • Steering lock unit (with advanced keyless system) • Related wiringharnesses • Key reminder switch (with keyless entry system) • Related wiring harnesses

E

Start knob is Pushed Steering lock unit (with advanced keyless Other system) Key inserted

G

Key...