First A. Author*. Second B. Author, Jr.** Third C. Author*** *National Institute of Standards and Technology, Boulder, CO 80305 USA (Tel: 303-555-5555; e-mail: author@ boulder.nist.gov). **Colorado State University, Fort Collins, CO 80523 USA (e-mail: author@lamar. colostate.edu) *** Electrical EngineeringDepartment, Seoul National University, Seoul, Korea, (e-mail: email@example.com)} Abstract: These instructions give you guidelines for preparing papers for IFAC conferences. Use this document as a template to compose your paper if you are using Microsoft Word 6.0 or later. Otherwise, use this document as an instruction set. Please use this document as a “template” to prepare your manuscript. Forsubmission guidelines, follow instructions on paper submission system as well as the Conference website. There is a very small blank line immediately above the abstract, do not delete it; it sets the footnote at the bottom of this column. Keywords: Include a list of 5-10 keywords, preferably taken from the IFAC keyword list. 1. INTRODUCTION This document is a template for Microsoft Word versions 6.0 orlater. If you are reading a paper version of this document, please download the electronic file, ifacconf.doc. If your paper is intended for an IFAC event, please contact the editor of the meeting concerning acceptable word processor formats for that particular event. Please do not put any running header/footer or page number in the submitted paper. You can type over sections of ifacconf.doc orcut and paste from another document and then use markup styles. The pulldown style menu is at the left of the Formatting Toolbar at the top of your Word window (for example, the style at this point in the document is “Text”). Highlight a section that you want to designate with a certain style, and then select the appropriate name on the style menu. The style will adjust your fonts and line spacing.Do not change the font sizes or line spacing to squeeze more text into a limited number of pages. Use italics for emphasis; do not underline. 1.1 A subsection Bifurcation: Plot of local maxima of x with damping a decreasing (Fig. 1). To insert images in Word, position the cursor at the insertion point and either use Insert | Picture | From File or copy the image to the Windows clipboard and thenEdit | Paste Special | Picture (with “Float over text” unchecked). IFAC will not do any final formatting of your paper. Your manuscript should be ‘camera-ready.’ Page limits vary from conference to conference. Please observe the page limits of the conference for which your paper is intended. Please do not modify margins. If you are creating a document on your own, please observe the margins aslisted in Table 1.
Fig. 1. Bifurcation: Plot of local maxima of x with damping a decreasing. 1.2 Another Subsection Text of the subsection. 2. PROCEDURE FOR PAPER SUBMISSION 2.1 Review Stage Please use this document as a “template” to prepare your manuscript. For submission guidelines, follow instructions on paper submission system as well as the Conference website.
Note that conferences imposestrict page limits, so it will be better for you to prepare your initial submission in the camera ready layout so that you will have a good estimate for the paper length. Additionally, the effort required for final submission will be minimal. 2.2 Final Stage Authors are expected to mind the margins diligently. Conference papers need to be stamped with conference data and paginated for inclusionin the proceedings. If your manuscript bleeds into margins, you will be required to resubmit and delay the proceedings preparation in the process. 2.3 Page margins All dimensions are in centimeters. Table 1. Page margins Page First Rest Top 3.5 2.5 Bottom 2.5 2.5 Left/Right 1.5 1.5
An exception is when English units are used as identifiers in trade, such as “3.5 in disk drive.” Avoid combining...