Ingeneria Bioquimica

Leaning Tower of Pisa, Italy: Assembly Instructions

Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe

Before starting assembly:Writing the number of each section on itsback side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out
the sections.)

http://www.canon.com/c-park/en/Reverse side of part 4

Glue the upper glue tabs of part 3
to the inside areas with circles on
the printed side of part 4.

3
View of completed model

Printed side of part 4

*This model wasdesigned for Papercraft and may differ from the original in some respects.

Assembly Instructions:Three A4 sheets(No.1 to No.3)
*Build the model by carefully reading the Assembly Instructions, in theparts sheet page order.

Carefully glue the lower glue tabs
of part 3 to the glue areas of part 1,
one at a time.

*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) toget a sharper, easier fold.

2

Assembly Instructions
Mountain fold(dotted line)

Make a mountain fold.
Valley fold(dashed and dotted line)

Make a valley fold.
Scissors line(solid line)Cut along the line.
Cut in line(solid line)

Cut along the line.

Tools and materials
Assembly tip
Caution

Glue
The glue spot(colored dot)
shows where to apply the glue.

Glue spot(Reddot)

Glue parts with the same shape together.
Glue spot(Green dot)

Glue within the same part.
Glue spot(Blue dot)

1

Glue to the rear of the other part.

Scissors, set square, glue(Werecommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make surerounded sections are nice and stiff.

Use parts 1 - 4 to build six identical components.

Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach...