Ingeniero

ISSUE DATE 0407
PAGE 1 OF 1

PRODUCT SPECIFICATION SHEET

I

15kV 200A Loadbreak Junction - 2 Way

TC

164J2
3.62"
92,0mm

17.50"
444,5mm

CONFORMS TO ANSI
Std 386, Fig 5

1.80"45,6mm

3.12"
79,4mm
.81"
20,6mm

8.10"
205,8mm

4.26"
108,2mm
11" TO 15.75"
27,9cm TO 40,0cm
MOUNTING

Ratings:
ELASTIMOLD junctions are designed for subsurface, vault or
padmountapplications and can be used for sectionalizing,
looping, tapping, and equipment bypass. Junctions are designed to mate with other ELASTIMOLD products including:
• 165LR elbow connector
• 166LRelbow connector
• 160GLR grounding elbow
• 370TR test rod
• 160DR/DRG, 167/168DR insulated cap
ELASTIMOLD loadbreak junctions, provide a fully shielded,
fully submersible, separable, insulatedassembly designed
for energized operation. They are suitable for use on 15-kV
class distribution systems, and rated for 200-ampere
loadmake/loadbreak operation. Junctions are equipped with
universalbrackets that accommodate curved or flat surfaces
and provide tilt mounting angles from 0o to 90 o in 15 o increments.

per ANSI/IEEE Standard 386
15kV Voltage Class
8.3kV Max Phase-to-Ground -Operating Voltage
14.4kV Max Phase-to-Phase
95kV BIL - Impulse Withstand (1.2 x 50 microsecond wave)
34kV AC - One minute Withstand
53kV DC - 15 Minutes Withstand
11kV AC - Corona Extinction @3p.C.sensitivity
200 Amp - Continuous and Loadbreak
10kA Sym - 10 Cycles Momentary & Fault Close

Ordering Instructions:
Specify 164J2 for 15kV, 200 Amp, 2-way Loadbreak Junction
Add “-5” at the endof the catalog number for junctions with “U”
style mounting straps only.
Add “-6” at the end of the catalog number for bracket only with
“U” strap and mounting hardware.
The 164J2 2-way Junctionkit contains the following:
1 – Basic Molded Junction
164J2
2 – Protective shipping cap
1601-APC-1
2 – Tube, lubricant
82-08
1 – Installation instruction
IS-0378

Thomas & Betts Corporation...