Instalacion baldosas de vinyl

AZROCK ASSET VINYL COMPOSITION TILE INSTALLATION AND MAINTENANCE PROCEDURES
Azrock Cortina Classics, Cortina Colors, Thru-Quartz, Solid Color, Granite, & Granite SR, 12” X 12”

I. GENERALINFORMATION These installation specifications are general guidelines for Azrock Vinyl Composition Tile. The latest edition of Azrock’s Installation and Maintenance Manual should be consulted for completedetails. Overall conditions should meet the following criteria: 1. All flooring material, accessories, and area to be installed must be kept at 65oF. (18.3oC) and no greater than 85°F (29.4°C) for atleast 48 hours previous to, during and 48 hours after installation. Maintain a minimum 55°F (12.8°C) afterward. 2. All subfloor/underlayment patching must be done with a quality Portland / hydrauliccement based latex underlayment material. 3. It is not recommended to install Azrock Vinyl Composition Tile over residual asphalt (cutback) adhesive. These residues must be covered over with appropriateunderlayment plywood or a quality Portland /hydraulic cement based latex underlayment material recommended for this procedure. 4. Azrock Vinyl Composition may be installed over an (1) existing layer ofon or above grade vinyl composition tile only. No other existing floor coverings are acceptable as a substrate. 5. Azock’s Thru-Quartz and Slip Resistant products should be installed following thedirectional arrows on the back of the tile. 6. Use the recommended TARKETT adhesives and trowel notches recommended for application: • Tarkett #100 Clear Thin Spread 1/32” (0.8mm) deep, 1/16” (1.6mm)wide, 1/32” (0.8mm) apart. • Tarkett #940 Polyurethane Adhesive (Specialized Wet Set) 1/32” (0.8mm) deep, 1/16” (1.6mm) wide, 1/32” (0.8mm) apart. (For Slip Resistant products in areas exposed totemperature and topical moisture extremes.) II. SUBFLOOR PREPARATION The finished appearance of any resilient floor covering will only be as good as the subfloor it is installed upon. The subfloor should...