Jumbo simba

ATLAS COPCO SIMBA H253

Features
The Simba H253 is an electric hydraulic top hammer long hole drill rig, designed to drill holes 51-89mm up to 30m in length. It is equipped with a console, whichcan be inclined 20º forward and 85º backwards in the longitudinal direction of the drill rig. The console serves as an attachment device for the feed beam, which is mounted, with the followingcomponents

SLIDE TABLE

ROTARY ACTUATOR

• Slide table – for parallel re-positioning of the feed beam in the lateral plane. • Rotary actuator – rotates the feed beam through 360 (in the lateral plane).SIMBA H253
Combined parallel-hole drilling (max. hole-spacing 1.5m without moving rig), 360˚ ring-drilling and fan drilling.

This configuration enables the rig to complete 360º ring drillingand parallel holes 1.5 m apart from the one set up position. The drill rig is stabilized during drilling by means of four extendable hydraulic jacks. The feed beam is fixed in the correct position bymeans of hydraulic stingers.

Specifications
• Weight 11,500 kw • Packed up travel height 3.3m, length 7.4m, width 2.4m • Diesel hydraulic tramming, 4 cylinder Deutz motor, Max Tramming Speed12km/hr • Carrier; 4 wheel drive articulated steering Hydraulic oil immersed disk brakes on both axles. Two-circuit system Parking / Emergency brakes • Electric hydraulic operation 1000v Hydraulic pumpmotor 55 kw Water booster pump 1.5 kw • 1238 Drifter uses R32, T38 or T45 running gear with a guide tube as lead rod • Carousel to suit 1.8m Rods • Angle reading instrument TransTronic 6G • Flushing waterrequirements at 12 bar 1.1 L/S • Equipped with electric remote control system for drilling operations • Segregated steel braided fuel lines • Power to run fuel solenoids • 45 L NFP Fire suppressionsystem • 4.5 kg Dry chemical powder fire extinguisher • Certified F.O.P.S. Canopy

Phone: (08) 9093 7600 Fax: (08) 9093 0388

Email: mail@perdrill.com.au

ATLAS COPCO SIMBA H253
LASER OFFSETS...