Manual Del 450 Axe

40Heli-Max™ AXE™ CP CNC Bell Hiller Upgrade
PACKAGE CONTENTS

❏ 2. Remove the oval linkages from the swashplate and flybar
control arm.
•
•
•
•
•
•

Two CNC Bell Hiller blade grips withmixers pre-installed
Two brass flybar weights
Four control rods
Two short spacers
Two long spacers
Four plastic blade spacers

INTRODUCTION

❏ 3. Remove the spindle bolt using a 1.5mm allenwrench.

The Heli-Max™ AXE™ CP Bell Hiller Uprade increases the control
rate and stability of your AXE CP drastically. The included adjustable
flybar weights must be installed for initial test flights.The flybar
weights reduce the sensitivity of the control system. Please keep in
mind that even with the flybar weights installed, the model will be 4 to
5 times more sensitive once you install theBell Hiller blade grips.
Once you have become accustomed to the new Bell Hiller blade grips,
you will notice the model is much more responsive and accurate to
your control inputs. You will alsonotice the model can be flown in
stronger winds and fast forward flight shows no instabilities.
If additional assistance is required for any reason contact Product
Support by e-mail athelihotline@hobbico.com, by telephone at
(217) 398-8970, or visit www.helimax-rc.com.

❏ 4. Remove the blade grip from the side you removed the spindle
screw from. Pull the other blade grip and spindle out of thehead block.

INSTALLING THE UPGRADE

❏ 1. Remove the main blade bolts using a 1.5mm allen wrench.
Remove both main rotor blades from the helicopter. Remove the
2mm nut from the bottom of the bladegrips. These will be needed
later when reinstalling main rotor blades.

❏ 5. Slide the spindle out of the blade grip and insert the spindle
into the new Bell Hiller blade grip. Slide a thindampening spacer
onto the spindle.

❏ 8. Remove all of the control links from the rotor head. Verify the
new linkages are the same length and have a 1mm gap between
the ball links. Please note...