Nortel

Nortel BCM-50 Programming Notes
 
Connect to the BCM50 web interface 
1. Connect the Ethernet port of your PC to the OAM port (port 0 on the far left) of the BCM50 using a crossover cable.
 2. Start your Internet browser.  In the address bar type 10.10.11.1, then press the Enter key.  You should now see the BCM50 web interface.  If not, go to step 3.
 
3. Left-click the startbutton, left-click Control Panel, left-click Network Connections.  Left-click the LAN connection.  At the lower left of the window under Details your IP address should read 10.10.11.2.  If it isdifferent, right-click the LAN connection, then left-click Properties.  Double-click the line that reads Internet Protocol.  Tick the button that reads “Use the following address.”  Change the IPaddress to 10.10.11.2, and change the subnet mask to 255.255.255.0.  Left-click OK.  Repeat step 2.
 
Program the BCM50 using a digital telephone 
1. Feature **CONFIG (266344)
2. User ID = SETNNA(738662) – press OK
3. Password = CONFIG (266344) – press OK
 
Change the IP address (LAN port 1) of the BCM50 using a digital telephone 
  1. Feature 9*8
  2. User ID = SETNNA (738662) –press OK
  3. Password = CONFIG (266344) – press OK
  4. “Feature Codes” is displayed – press NEXT 2 times
  5. “IP ADDRESS” is displayed – press OK
  6. “IP ADDRESS” is displayed – press CHANGE  7. “DHCP: Enabled” is displayed – press DIS
  8. “192.168.1.2” is displayed (default IP address) – press CHANGE
  9. Enter new IP address using * as the “dot” between groups of numbers – pressOK
10. “255.255.255.0” is displayed (default subnet mask) – press CHANGE
11. Enter new subnet mask using * as the “dot” between groups of numbers – press OK
12. “192.168.1.1” is displayed(default gateway address) – press CHANGE
13. Enter new gateway address using * as the “dot” between groups of numbers – press OK
14. The BCM must be restarted before any changes made will take...