Parametros De Comunicacion Fanuc

|
| | |
| |
| |
| |
| |
| Communications standard non handshaking cable |
| 6 = Data Set Ready
7 = Signal Ground
8 = Carrier Detect
20 = Error (Data Terminal Ready)
25= Power |
| Baudrate-Feet
2400-400ft
4800-200ft
9600-100ft
19200- 50ft
38400-25ft
57600-16ft
115200-8ft |
|   |
| Fanuc ISO Protocol communication settings: (E,7,X)The standardprotocol for Fanuc controls is 4800 or 9600 Baud, Even parity, 7 data bits and either 1 or 2 stop bits (XON/XOFF, PUNCH ON/OFF). This is standard setting that will work in most conditions. Depending onenvironment and cable type and distance to DNC if used. |
| |
Fanuc Control Parameter settings RS232 Fanuc-3 RS232 | Fanuc-3 | | |
Parameter | Value | Comments |
0014 | | |
0069 | 4800 |Baud rate |
TV CHECK | 0 | 0: Off; 1: On |
Punch code | 0 | 0:ISO; 1:EIA |
|
Fanuc 6 and 9 series RS232 | Fanuc 6 and 9 series | | | | Baud rate | Parameter |
50 | 00010000 |
100 |00010001 |
110 | 00010010 |
150 | 00010011 |
200 | 00010100 |
300 | 00010101 |
600 | 00010110 |
1200 | 00010111 |
2400 | 00011000 |
4800 | 00011001 |
9600 | 00011010 |
|
Parameter| Value | Comments | | |
311 | 00011000 | Baud rate 2400 | | |
340 | 2 |   | | |
341 | 2 |   | | |
TV CHECK | 0 | 0: Off; 1: On | | |
Punch code | 0 | 0:ISO; 1:EIA | | |
Inputunit | 0 | RS232C | | |
Input device 1 | 1 |   | | |
Input device 2 | 1 |   | | |
|
Fanuc 0M RS232 | Fanuc 0M On the SETTINGS screen, set the following:
TVON =0
ISO = 1
I/O = 0 (port1), I/O = 2 (port 2)
PWE = 1
TAPEF = 0 | CNC
Parameter | Port 1
(M5) | Port 2
(M74) | |
| 0002 | 1xxxxxx1 | no effect | |
| 0050 | no effect | 1xxxxxx1 | |
| 0038 | 01xxxxxx |xx01xxxx | |
| 0552 | 9-Baud rate: 2400 | no effect | |
| 0253 | no effect | 10 | |
X means can be 0 or 1 | | | | |
|
Fanuc-
0i-M/0i-T RS232 communication | Fanuc | 0i-M/0i-T | |...