Trabajo De Musica

PCBOWAU2G Installation Guide

Before you proceed with the installation, please note the following: Note 1: The following installation was operated under Windows XP. (Procedures are similar for Windows 98SE/Me/2000.) Note 2: If you have installed the WLAN USB driver & utility before, please uninstall the old version first. Note 3: Insert your installation CD it will be auto run direct if notplease open My Computer, double Click the Patriot drive icon named AutoRun will begin installation.

1. Installation 1. Connect the wireless adapter to desired available USB 2.0 port. 2. Insert provided utility/driver CD into CD-rom drive 3. Install drivers from CD.

4. if windows prompt to install driver cancel and install driver from provided CD instead

5. Click Next to process theinstallation. .

5. Click Install to proceed.

6. On Windows Logo Software Installation screen, click Continue Anyway to continue. Note: Not all the drivers will have this message box.

7. Click Finish to complete the installation.

8. After setup, restart your computer

2. Remove Driver If uninstalling is need follow these steps

A. Uninstall the WLAN USB Adaptor Driver from “WirelessNetwork Driver and Utility” or “Control Panel”. Click “Uninstall” (or “Change/Remove”) to remove Wireless LAN USB Adaptor driver. B. Click “OK” if you want to remove Wireless LAN USB Adaptor Driver .

C. Click “Finish” to complete removal of the driver.

Making a Basic Network Connection

In the following instructions are for making a network connection.

Note: For Windows XP users that want toconfigure your wireless network using this Utility, please perform the following procedures to disable your native Windows XP wireless support (Wireless Zero Configuration Service)

1. Double click the

icon on your desktop to start the utility OR

in the task bar.

Ad-Hoc Mode An Ad-Hoc mode wireless network connects two computers directly without the use of a router or AP. It is alsoknow as a peer-to-peer network.

To use this adapter in Ad-Hoc Mode

1. Double click the

icon on your desktop to start the utility or

in the task bar.

2. Click the “Available Network” button to scan available wireless network adapters. Double click on the network adapter that you are going to connect to.

3. Click the OK button to confirm that you are connecting to an open wirelessnetwork.

4. Click OK to add this network into the profile list.

Note: This example is an open wireless network. If you are going to connect to a Wireless adapter with security protection, you will have to configure the encryption settings in this profile to be corresponding to the other wireless adapter. Please click on the “Network Authentication” drop list to select an authenticationmethod, and then select a “Data encryption” type. Fill in each required blanks and click “OK”.

Infrastructure mode An Infrastructure Mode network contains at least one wireless client and one wireless AP or router. This client connects to Internet or intranet by communicating with this wireless AP.

To use this adapter in Infrastructure Mode:

1. Double click the

icon on your desktop tostart the utility or

in the task bar.

2. Click the “Available Network” button to scan available access points. Double click on the AP that you are going to connect to.

3. Double click to create profile that you are connecting to an open wireless network.

4. Click OK to add this network into the profile list.

Note: This example is an open wireless network. If you are going to connectto an AP with security protection, you will have to configure the encryption settings in this profile to be corresponding to your AP. Please click on the “Network Authentication” drop list to select an authentication method, and then select a “Data encryption” type. Fill in each required blanks and click “OK”.

Tip: Windows XP and Windows 2000 users is also allowed to connect to your wireless...