Hola

MULTIFUNCTIONAL DIGITAL SYSTEMS

e-STUDIO162/162D e-STUDIO151/151D

File No. SME04003200 R04112171700-TTEC Ver00_2005-01

© 2005 TOSHIBA TEC CORPORATION All rights reserved

Parts marked with “ ” are important for maintaining the safely of the machine. Be sure to replace these parts with the replacement parts specified to maintain the safety and performance of the machine.

GENERALPRECAUTIONS REGARDING THE INSTALLATION AND SERVICE FOR e-STUDIO162/162D/151/151D
The installation and service should be done by a qualified service technician. 1. Transportation/Installation • When transporting/installing the machine, be sure to use the positions as indicated below. The machine is quite heavy and weighs approximately 16.8 kg (37 lb.), therefore pay full attention when handling it.• Be sure to use a dedicated outlet with AC 110A, 115V or 127V/8A, 220V-240V or 240V/5A for its power source. • The machine must be grounded for safety. Never ground it to a gas pipe or a water pipe. • Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. • Also provide proper ventilation as the machine emits a slight amount ofozone. • The socket-outlet shall be installed near the machine and shall be easily accessible. 2. Service of Machines • Basically, be sure to turn the main switch off and unplug the power cord during service. • Be sure not to touch high-temperature sections such as the exposure lamp, the fuser unit and their periphery. • Be sure not to touch high-voltage sections such as the chargers and thehigh-voltage transformer. Especially, the board of these components should not be touched since the electric charge may remain in the capacitors, etc. on them even after the power is turned OFF. • Be sure not to touch rotating/operating sections such as gears, belts, pulleys, fan, etc. • Be careful when removing the covers since there might be the parts with very sharp edges underneath. • When servicing themachines with the main switch turned on, be sure not to touch live sections and rotating/operating sections. Avoid exposure to laser radiation. • Use suitable measuring instruments and tools. • Avoid exposure to laser radiation during servicing. - Avoid direct exposure to the beam. - Do not insert tools, parts, etc. that are reflective into the path of the laser beam. - Remove all watches, rings,bracelets, etc. that are reflective. • Unplug the power cable and clean the area around the prongs of the plug once a year or more. A fire may occur when dust lies on this area.

3.

Main Service Parts for Safety • The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly important for safety. Be sure to handle/install them properly. If these parts are shortedcircuit and/or made their functions out, they may burn down, for instance, and may result in fatal accidents. Do not allow a short circuit to occur. Do not use the parts not recommended by Toshiba TEC Corporation.

4.

Cautionary Labels • During servicing, be sure to check the rating plate and the cautionary labels such as “Unplug the power cord during service”, “Hot area”, “Laser warninglabel” etc. to see if there is any dirt on their surface and whether they are properly stuck to the machine.

5.

Disposition of Consumable Parts, Packing Materials • Regarding the recovery and disposal of the machine, supplies, consumable parts, packing materials, follow the relevant local regulations or rules.

6.

When parts are disassembled, reassembly is basically the reverse ofdisassembly unless otherwise noted in this manual or other related documents. Be careful not to reassemble small parts such as screws, washers, pins, E-rings, star washers in the wrong places.

7. 8.

Basically, the machine should not be operated with any parts removed or disassembled. Precautions Against Static Electricity • The PC board must be stored in an anti-electrostatic bag and handled...