Programming Guide

Programming |
Virtually all SSB communications are conducted using the frequency and mode data stored in the 160 radio channels/memory locations in the User Channel Group. Any or all of these 160User Memory Channels can be reprogrammed either manually, or by computer. Here's how to manually reprogram a User Channel:There are two large knobs, a keypad, and a Mode button on the front of theradio. These are the tools used to reprogram frequency and mode data in the radio. * The large left-hand knob is the Group Channel Selector knob. Use it to  select the channel group you want to use. *The right-hand knob is the Channel Selector knob. Use the Channel Selector knob to select a radio channel within a selected Channel Group. * The CH/Freq keypad key toggles the radio LCD dialdisplay between Channel and Frequency. * The Mode button selects USB, LSB, H3E, etc., modes. Note: ALL marine SSB communications are conducted in the USB mode.Programming the M710 is a three-stepprocess:Step-1: Program the Receive Frequency.
Step-2: Program the Transmit Frequency.
Step-3: Rewrite the channel name/label.M-710/710RT Programming: |
Program the Receive Frequency |
1. Turn theradio on. 2. Rotate the Group Channel Selector Knob until you have found the User Channel Group. 3. Turn the Channel Selector Knob to the radio channel to be programmed. 4. Press & releasethe CH/Freq keypad button until the LCD display shows frequency. 5. Press the CE keypad key. A caret symbol { ►} will appear on the top line of the dial LCD display. 6. Press the MODE button untilUSB (J3E) mode shows on the LCD display. 7. Enter the new receive frequency using the keypad. 8. Press and hold the RX keypad key until the caret disappears. The new receive frequency is nowstored. |
Program the Transmit Frequency |
1. Press the TX keypad key. "TX" will flash on line two of the dial LCD. 2. Press the CE keypad key. A caret symbol { ►} will appear next to of the...