Aviación

Airplane, also called AEROPLANE, or PLANE, any of a class of fixed−wing aircraft that is heavier than air,
propelled by a screw propeller or a high−velocity jet, and supported by the dynamic reaction of the air against
its wings. Two kinds of aircraft without fixed wings that are classified as airplanes are the STOL airplane and
the VTOL airplane. A brief treatment of airplanes follows.
Fortreatment of historical aspects, see Transportation; for manufacturing technology, see Industries,
Manufacturing; for military aspects, see War, The Technology of.
The essential components of an airplane are a wing system to sustain it in flight, tail surfaces to stabilize the
wing, movable surfaces (ailerons, elevators, and rudders) to control the attitude of the machine in flight, and a
powerplant to provide the thrust to push the craft through the air.
An enclosed body (fuselage) houses the crew, passengers, and cargo, as well as the controls and instruments
used by the navigator. An airplane also requires a support system (such as wheels or pontoons) when it is at
rest on a surface and during takeoff and landing.
Most airplanes in use today are monoplanes (i.e., aircraft with asingle pair of wings). They are termed
high−wing when the wing is attached at the top of the fuselage, midwing when it extends from or near the
centre of fuselage section, and low−wing when the wing structure fastens to the fuselage structure at the
bottom. The multiplane with two or more horizontal wing systems, one above the other, connected by a series
of struts and wires, has virtuallydisappeared. The few biplanes still in service are used mainly for sport flying or for agricultural crop dusting. Monoplanes
may be characterized by the planform (top view) of their wings, which may be rectangular, tapered,
swept−back, or delta. A so−called variable−geometry concept incorporating adjustable sweepback is a
compromise to obtain good high− and low−speed characteristics from the samewing.
For takeoff and landing, hinged wing panels are extended at right angles to the fuselage in order to utilize the
advantages of long−span and high−aspect ratio. For high speed and maneuvering in flight, the panels are
swung rearward to make (with the tail surfaces) a delta configuration. The normal location for stabilizers, fins,
rudders, and elevators is well behind the wing, mounted onthe tapered tail section of the fuselage.
The standard arrangement (until the advent of jet engines) was a cruciform assembly, with vertical fins and
rudders and horizontal stabilizer and elevators forming a cross, the axis of which was approximately
coincident with the fuselage axis. In some large, high−wing airplanes with relatively short, large−diameter
fuselages, airflow over thehorizontal tail surfaces was disturbed to the extent that control effectiveness under
some flight conditions was compromised.
Also, in designs in which jet pods were to be mounted at the after end of the fuselage, it was necessary to
relocate the horizontal surfaces to keep them clear of the jet blasts.
The solution was the so−called T−tail configuration, in which the horizontal surfaces were mountedat the top
of the vertical fin structure. Where three jet engines are used, the fin structure may incorporate the air intake
for the centre engine or the entire engine pod. The consequent increase in weight of the tail structure has
changed the appearance of many airplanes.
To maintain a viable relationship between centre of lift of the wings and th
To maintain a viable relationship betweencentre of lift of the wings and the airplane's centre of gravity, the
wings were moved aft and the nose section of the fuselage was extended far forward for proper balance. For
two− or four−engined planes (either piston engine or turbine−propeller combinations or turbojets), the power
plants are normally distributed outboard along the wings, either in nacelles projecting from wing and edges or...