Brother Lc-51
| 1) Cut label at joint between top and bottom halves of the cartridge case. 2) Flip open the cartridge casing (shell). 3) Removethe cartridge from the casing (shell).4) There is a round hole (well) in the top of the cartridge. Inside the hole or well is a rubber stopper. Use athumb drill and drill through the rubber stopper.
Note: Do not bump or press the "pressure release button".5) Put the blunt filling needle onto thesyringe and fill the syringe with ink.6) Insert the blunt needle through the drilled stopper hole and into the cartridge body. Be sure the needle (eventhough it is blunt) does not press up against the bag and punctures it.7) S-l-o-w-l-y inject 15cc of ink into the cartridge bag.8)Remove the syringe withneedle and Seal the hole using the small set screw and allan wrench provided. 9) Place the cartridge back into it's casing (shell) and use a piece oftape to hold the two sides of the casing (shell) together. 10) Replace the cartridge(s) and run 1 - 3 cleaning cycles as per printer instructions.
Orprint the following pages:
http://www.refillinstructions.com/black.htm for Black
http://www.refillinstructions.com/color.htm for Color A RefillKit should include Ink plus the following:
3- 30cc Syringes with blunt needles for Color
1 - 30cc Syringe with blunt needle for Black
1 Thumb Drill
1Small Allan Wrench
1 Small Set Screw per color
Aluminum Tape |
www.PrinterFillingStation.com
Printer ink and Refill kits for your Printer |
|
Regístrate para leer el documento completo.