Ccna
Example Configuration
1) Set up the ip addresses Click on IP -> Addresses
Click on the red + sign to add an ip address
CopyrightWi-Pipe
Page 1
Enter the address in the format aaa.bbb.ccc.ddd/nn where /nn is the subnet mask. i.e. 192.168.1.1/24 = ip address 192.168.1.1, subnet 255.255.255.0.Ensure the interface is ether1, then click on ok
Repeat to add an ip address for the WLAN1 interface
Copyright Wi-Pipe
Page 2
Copyright Wi-Pipe
Page 3
2) Setupthe wireless interface Click on wireless
Select WLAN1 and enable it by clicking on the blue tick icon
Double click on the interface to edit it’s details Select the wirelesstab
Select the frequency band from the frequency drop down list
Copyright Wi-Pipe
Page 4
Click on apply (IMPORTANT!) Click on scan and then click on start todiscover networks in range
Select the required network, click on connect and then click on close Click on ok to save changes An ‘R’ will appear beside the interface to show that itis connected and Running.
Copyright Wi-Pipe
Page 5
3) Set up routing Select IP -> Routing
Click on the red + to add the gateway Enter the gateway address and clickon ok
Copyright Wi-Pipe
Page 6
Click on IP -> Firewall
Click on the red + to add a firewall rule In the general tab select the chain srcnat and out Interfacewlan1.
Copyright Wi-Pipe
Page 7
Click on the action tab Select masquerade and click on ok
Copyright Wi-Pipe
Page 8
The MikroTik client is now configured. Forfurther information on other configuration options please refer to : http://www.mikrotik.com/testdocs/ros/2.9/ http://forum.mikrotik.com/
Copyright Wi-Pipe
Page 9
Regístrate para leer el documento completo.