Cnna Iv Final Violentkain

52. (1) A network administrator is tasked with maintaining two remote locations in the same city. Both locations use the same service provider and have the same service plan for DSL service. When comparing download rates, it is noticed that the location on the East side of town has a faster download rate than the location on the West side of town. How can this be explained?

The West side has ahigh volume of POTS traffic.

The West side of town is downloading larger packets.

The service provider is closer to the location on the East side.

More clients share a connection to the DSLAM on the West side



37. (3) Which Frame Relay flow control mechanism is used to signal routers that they should reduce the flow rate of frames?

DE

BE

CIR

FECN

CBIR



44. (4)Refer to the exhibit. A network administrator is attempting to configure a Frame Relay network. The administrator enters the commands as shown in the exhibit on R2, but the Frame Relay PVCs are inactive. What is the problem?

The incorrect DLCI numbers are being configured on R2.

The S0/0/0 interface on R2 needs to be point-to-point.

The frame-relay map commands are missing the ciscokeyword at the end.

A single router interface cannot connect to more than one Frame Relay peer at a time.



22. (8) Refer to the exhibit. Results of the show vlan and show vtp status commands for switches S1 and S2 are displayed in the exhibit. VLAN 11 was created on S1. Why is VLAN 11 missing from S2?

There is a Layer 2 loop.

The VTP domain names do not match.

Only one switch can bein server mode.

S2 has a higher spanning-tree priority for VLAN 11 than S1 does.





36. (22) Refer to the exhibit. Based on the output as shown, which two statements correctly define how the router will treat Telnet traffic that comes into interface FastEthernet 0/1? (Choose two).

Telnet to 172.16.10.0/24 is denied.

Telnet to 172.16.20.0/24 is denied.

Telnet to 172.16.0.0/24 ispermitted.

Telnet to 172.16.10.0/24 is permitted.

Telnet to 172.16.20.0/24 is permitted.





4. (10) Which option correctly defines the capacity through the local loop guaranteed to a customer by the service provider?

BE

DE

CIR

CBIR



49. (18) Refer to the exhibit. R1 is performing NAT overload for the 10.1.1.0/24 inside network. Host A has sent a packet to the webserver. What is the destination IP address of the return packet from the web server?

10.1.1.2:1234

172.30.20.1:1234

172.30.20.1:3333

192.168.1.2:80



21. (20) Refer to the exhibit. Which data transmission technology is being represented?

TDM

PPP

HDLC

SLIP



2. (21) Which three guidelines would help contribute to creating a strong password policy? (Choose three.)Once a good password is created, do not change it.

Deliberately misspell words when creating passwords.

Create passwords that are at least 8 characters in length.

Use combinations of upper case, lower case, and special characters.

Write passwords in locations that can be easily retrieved to avoid being locked out.

Use long words found in the dictionary to make passwords that areeasy to remember.



51. (25) When Frame Relay encapsulation is used, what feature provides flow control and exchanges information about the status of virtual circuits?

LCP

LMI

DLCI

Inverse ARP



46. (36) Which combination of Layer 2 protocol and authentication should be used to establish a link without sending authentication information in plain text between a Cisco and anon-Cisco router?

PPP with PAP

PPP with CHAP

HDLC with PAP

HDLC with CHAP



50. (40) Refer to the exhibit. All devices are configured as shown in the exhibit. PC1 is unable to ping the default gateway. What is the cause of the problem?

The default gateway is in the wrong subnet.

STP has blocked the port that PC1 is connected to.

Port Fa0/2 on S2 is assigned to the wrong VLAN....