Jhklshgkds

Catalog 8000-2/USA
Indexer

Controller

VM50 Adaptor
If you wish to use screw terminal connections for the 24 programmable I/O, Compumotor offers the VM50 adaptor (p/nVM50). Screw terminal connections for both the 24 inputs and the 24 outputs will require two VM50 adaptors.
2 4

Programmable I/O Connectors

2-Foot Cable (provided withVM50)

VM50 snaps on to any standard DIN Rail

Overall height 2.28 (58)
6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 50

The pin numbers on the VM50’sscrew terminals correspond to the same pin outs on the Programmable Inputs and Programmable Outputs connectors. The VM50 simply attaches to the controller via the 2-foot, 50-pinribbon cable that comes with the VM50 (see figure on right).

3.03 (77)
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 49

VM50 Adaptor Board
5.31(135)

Specifications
Parameter Output Sourcing Current Value OFF = Equivalent to GND of load ON - V0–2VDC for 50 mA ON = V0–2.5VDC for 500 mA OFF = V0 ON = ≤ 0.4VDC for 50 mAON = < 2.5VDC for 500 mA 5–24V Default is active low, but can be changed to active high with the OUTLVL command

Sinking Current

V0 Range Active Level
Input Switchinglevels Vi Range Voltage Range Sourcing Current Sinking Current Status Active Level

Note: Outputs are not short-circuit protected.
Low ≤ 1/3 (Vi ) High ≥ 2/3 (Vi ) 5–24V 0–24VConnect jumper for desired socket to position 3 (default) Connect jumper for desired socket to position 1 Check with the TIN or INFNC command Set by 6000 Seriescontroller/indexer. Default is active low, but can be changed to active high with the INLVL command.

C118

Parker Hannifin Corporation Compumotor Division Rohnert Park, California