STANDARD EQUIPMENT LIST AIRCRAFT
DESCRIPTION 1. FUSELAGE:
Metallic monocoque aluminum alloy.
1.A- ENGINE SECTION:
Rotax engine mount four (4) strokes. (Preengine mount is optional for Rotax engine 80 hp and 100 hp).
Cowling - easily removable 2 inspection covers (superior and inferior) in fiberglass.
.Engine inspections caps in fiberglass -superiorcover - side by side.
1.B- CABIN SECTION:
Windshield of polycarbonate plastic, highly resistant to impacts (lexan 2mm). Dual adjustable fresh air vents (snap vents).
Cabin windows in ceiling andrear of polycarbonate plastic (lexan 2mm).
Cabin laterals window of polycarbonate plastic (lexan 2mm).
Dual doors (open system up) with gas spring assisted opening.
2. CABIN FEATURES:Doors with two (2) points closed, front and rear with security lock. Each door open with the same key on both sides, pilot and copilot, with handles for easy opening from the inside and outside. Windowsof polycarbonate plastic (lexan 2mm).
Two (2) thick padded and folding seats side by side (adjustable forward and back). Seats side by side thick padded and upholstered with leather and syntheticmaterial with head rest.
Super plush interior cabin floor and baggage floor.
Cargo tie downs in baggage.
Rear cabin baggage compartment completely carpeted.
Lap belts three points (pilot &passenger).
Internal cabin windows in ceiling.
Seats and rails completely galvanized / iridescence, a better sliding in the point of the rails.
Fiberglass instrument panel with 3 section inaluminum sheet. Dual pilot yoke grips control in fiber glass for pilot and copilot. Central throttle controls. Dual aluminum pedals for pilot and copilot (rudder and nose wheel control).
Pedalssystem totally galvanized/iridescent .
Internal yokes and throttle system totally galvanized/ iridescent.
3. CONTROL SYSTEM FEATURES:
Wings profile naca 650-18m.
Wings with differential...