Sistema De Incendio

FIRE

4100U/4100/4120/4020 SafeLINC Fire Panel Internet Interface (FPII)

TM

Installation, Setup, & Operating Instructions

Copyright and Trademarks

Copyright

2003 Tyco Safety Products Westminster, Westminster, MA 01441-0001 USA. All specifications and other information shown were current as of document revision date, and are subject to change without notice.

TrademarksTyco, SafeLINC, TrueAlarm, Simplex, and the Simplex logo are registered trademarks of Tyco International Services AG or its affiliates in the U.S. and/or other countries. Microsoft is a registered trademark of Microsoft Corporation. Windows is a trademark of the Microsoft Corporation. All other logos and product names are trademarks or registered trademarks of their respective companies.i

Cautions and Warnings

READ AND SAVE THESE INSTRUCTIONS. Follow the instructions in this installation manual. These instructions must be followed to avoid damage to this product and associated equipment. Product operation and reliability depends upon proper installation. ELECTRICAL HAZARD - Disconnect electrical power when making any internal adjustments or repairs. Servicing shouldbe performed by qualified representatives of your local Simplex® product supplier. STATIC HAZARD - Static electricity can damage components. Therefore, handle as follows: • •
Caution to the User

Ground yourself before opening or installing components. (Use the 553-484 Static Control Kit.) Prior to installation, keep components wrapped in anti-static material at all times.

The user iscautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Upon unpacking your Simplex product, inspect the contents of the carton for shipping damage. If damage is apparent, immediately file a claim with the carrier and notify your local Simplex product supplier. In the event ofequipment malfunction, a representative of your local Simplex product supplier should perform all repairs. It is the responsibility of users requiring service to report the need for service to your local Simplex product supplier.

Inspecting Contents of Shipment

Service Requirements

ii

Contents
Introduction to the SafeLINCFPII................................................................... 1 Introduction .................................................................................................. 1 Overview ...................................................................................................... 1 Requirements................................................................................................ 2 SafeLINC FPII Card Illustration.................................................................. 2 SafeLINC FPII Card Specifications ................................................................. 3 General Temperature/Humidity Requirements............................................. 3 Specific Temperature/Humidity Requirements ............................................ 3 PowerRequirements..................................................................................... 3 Configuring the SafeLINC FPII Card .............................................................. 4 Overview ...................................................................................................... 4 Setting Communications .............................................................................. 4 Setting Computer Port Protocol(CPP) Functionality................................... 4 Setting the Baud Rate and Address .............................................................. 5 Mounting the SafeLINC FPII Card .................................................................. 7 Overview ...................................................................................................... 7 4100U Mounting...