Sustainability And The Built Environment Uc Davis Extension

Sustainability and the Built Environment UC Davis Extension

Applied Research Paper: Autoclaved Aerated Concrete as a Green Building Material Stefan Schnitzler October 2006

INTRODUCTION Autoclaved aerated concrete (“AAC”), though relatively unknown in the United States, is currently one of the many building products being touted as “green” or “environmentally friendly.” This paper brieflyexamines the advantages and disadvantages of building with AAC, paying particular attention to the aspects of the product that may lend to its designation as a sustainable building material. AUTOCLAVED AERATED CONCRETE – BACKGROUND Though largely new to the United States, AAC is not a new building material. Developed in Sweden in the 1920s in response to increasing demands on timber supplies, AACis a lightweight manufactured building stone. Comprised of all natural raw materials, AAC is used in a wide range of commercial, industrial, and residential applications and has been in use in Europe for over 70 years, the Middle East for the past 40 years, and South America and Australia for approximately 20 years. 1 According to one manufacturer, AAC now accounts for over 40% of all constructionin the United Kingdom and more than 60% of construction in Germany. 2 The Manufacturing Process Autoclaved aerated concrete is a precast product manufactured by combining silica (either in the form of sand, or recycled flyash), cement, lime, water, and an expansion agent - aluminum powder, and pouring it into a mold. With respect to structurally reinforced AAC products like lintels or roof panels,steel rebar or mesh is also placed in the mold. Once added to the concrete, the aluminum powder reacts with the silica, resulting in the formation of millions of microscopic hydrogen bubbles. The hydrogen bubbles cause the concrete to expand to roughly five times its original volume. The hydrogen subsequently evaporates, leaving a highly closed-cell aerated concrete. The now aerated concrete iscut into blocks or panels which are then steam and pressurecured in an autoclave. AAC Product Types AAC, unlike traditional concrete masonry units (“CMU”), is a solid block/material system with integrated insulative and structural components, and is available in a variety of products that can be used in both load and non-load-bearing applications. Complete load bearing applications, however, arelimited to low-rise construction, though cladding and large panels are available to take advantage of AAC’s insulative, fire proofing, and other benefits on mid- and high-rise projects. Additionally, the large wall, floor, and roof panels, measuring up to 20 feet long, 2 feet wide, and in
AAC has been used in the United States for approximately 10 years. The United States’ late adoption of thematerial is likely due to 1) the high initial capital expenditures required in setting up domestic AAC manufacturing facilities, and 2) the fact that, unlike many of the countries where AAC is an established product, the vast majority of residential buildings in the United States utilize timber-frame construction. 2 See TruStone America, http://www.trustoneamerica.com/what.html
1

variousthicknesses, are also used in load-bearing capacities and are common in commercial and industrial applications. The remainder of the AAC system consists of blocks, also called “units” which are stacked using thin-set mortar, as opposed to the traditional cement-based mortar used in CMU construction. The blocks are available in a variety of sizes and types, e.g., 1) standard blocks, typically measuring 24inches long, 8 inches high, and in thicknesses between 6 (non-load-bearing) and 12 inches; 2) jumbo blocks, which reduce construction time; 3) U-blocks, which have a channel running the length of the block that once filled with concrete, provides structural support as headers and on the top course of each floor (the “bond beam”); and 4) cored blocks, which are used adjacent to corners and...