Vriado
Product Identity:
Sealed Lead Battery
Revision Date: July 5, 2009 Supersedes: November 16, 2007 Document #: MSDS 853027 Revised on ECO: 1000751
Cyclon, Genesis, SBS, SBS J, Hawker XE Odyssey or Trolling Thunder
Manufacturer's Name and Address: EnerSys Energy Products Inc. (formerly Hawker EnergyProducts Inc.) 617 North Ridgeview Drive Warrensburg, MO 64093-9301 Emergency Telephone Number: (660) 429-2165 Customer Service Telephone Number: 800-964-2837
SECTION II - Ingredients
Hazardous Components
Lead Lead Dioxide Sulfuric Acid Electrolyte Non-Hazardous Materials
CAS #
7439-92-1 1309-60-0 7664-93-9 N/A
OSHA PEL-TWA
50g/m3 50g/m3 1.0 mg/m3 N/A
% (By weight)
45 - 60 % 15- 25 % 15 - 20 % 5 - 10 %
SECTION III - Physical/Chemical Characteristics
Boiling Point - N/A Vapor Pressure (mm Hg.) - N/A Solubility in Water - N/A Specific Gravity (H2O=1) - NA Melting Point - N/A Appearance & Color - N/A
SECTION IV - Fire & Explosion Hazard Data
Flash Point (Method Used): N/A Flammable Limits: N/A LEL: N/A UEL: N/A Extinguishing Media: Multipurpose Dry chemical, CO2or water spray. Special Fire Fighting Procedures: Cool Battery exterior to prevent rupture. Acid mists and vapors in a fire are toxic and corrosive. Unusual Fire and Explosion Hazards: Hydrogen gas may be produced and may explode if ignited. Remove all sources of ignition.
SECTION V- Reactivity Data and Shipping/Handling Electrical Safety
Conditions to Avoid: Avoid shorting, high levels ofshort circuit current can be developed across the battery terminals. Do not rest tools or cables on the battery. Avoid over-charging. Use only approved charging methods. Do not charge in gas tight containers. Requirements for Safe Shipping and Handling of Cyclon Cells: Warning – Electrical Fire Hazard – Protect Against Shorting Terminals can short and cause a fire if not insulated during shipping. Cyclon product must be labeled “NONSPILLABLE” during shipping. Follow all federal shipping regulations. See section IX of this sheet and CFR 49 Parts 171 through 180, available anytime online at wwww.gpoaccess.gov. Requirements for Shipping Cyclon Product as Single Cells Protective caps or other durable inert material must be used to insulate each terminal of each cell unless cells areshipping in the original packaging from EnerSys, in full box quantities. Protective caps are available for all cell sizes by contacting EnerSys Customer Service at 1-800-964-2837. Requirements for Shipping Cyclon Product Assembled Into Multicell Batteries Assembled batteries must have short circuit protection during shipping. Exposed terminals, connectors, or lead wires must be insulated with adurable inert material to prevent exposure during shipping.
SECTION VI - Health Hazard Data
Routes of Entry: N/A Emergency & First Aid Procedures: Health Hazards (Acute & Chronic): N/A Battery contains acid electrolyte which is absorbed in the separator material. If battery case is punctured, completely flush any released material from skin or eyes with water.
Page 1 of 2
SECTION VI -Health Hazard Data (Continued)
Proposition 65: Warning: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Batteries also contain other chemicals known to the State of California to cause cancer. Wash hands after handling.
SECTION VII - Precautions for Safe Handling & Use
Steps to betaken in case material is released or spilled: Waste Disposal Method: Avoid contact with acid materials. Use soda ash or lime to neutralize. Flush with water. Dispose of in accordance with Federal, State, & Local Regulations. Do not incinerate. Batteries should be shipped to a reclamation facility for recovery of the metal and plastic components as the proper method of waste management....
Regístrate para leer el documento completo.