Manual Lx300+

EPSON

®

n

EPSON AMERICA, INC.

24-PIN DOT MATRIX PRINTER

TM-LX300

S ervice Manual

Revision Level

Revision

Date

EPSON®
@ Printed on Recycled Paper.

FCC Compliance Statement
For American Users
This equipment has been tested and found to comply with limits for a Class B digital device pursuant to Part
15 of FCC Rules. These limits are designed to providereasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment doescause interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the interference by one or more of the following
measures:
oReorient or relocate the receiving antenna.
oIncrease the separation between the equipment and the receiver.
oconnect the equipment into an outlet on a circuit different from theone connected to the receiver

For Canadian Users
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set
out in the radio interference regulations of the Canadian Department of Communications.
Le present appareil numerique n’emet p as de bruits radioelectrique depassant l es limites applicables a ux
appareils numeriques de Classe Bprescrites dans le reglement sur le brouillage radioelectriques Cdicte par le
Minister-e des Communications du Canada.

Caution
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification of this device and may cause interference levels which exceed the limits established by the FCC
for this equipment. It is the responsibility of the userto obtain and use a shielded equipment interface cable
with this device. If this equipment has more than one interface connector, do not leave the cables connected to
unused interfaces.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.

Copyright Notice
All rights reserved. No part of this publication may bereproduced, stored in a retrieval system, or transmitted
in any form or by any means, electric, mechanical, photocopying, recording, or otherwise, without the written
permission of Epson America, Inc. No patent liability is assumed with respect to use of the information
contained herein. Neither is any liability assumed for damages resulting from the use of the information
contained herein. Whileevery precaution has been taken in the preparation of this book, Epson America, Inc.,
assumes no responsibility for errors and omissions.
Neither Epson America, Inc., nor its affiliates shall be liable to the purchaser of this product or third parties for
damages, losses, costs, or expenses incurred by purchaser or third parties as a result of accident, misuse, or
abuse of this product orunauthorized modifications, repairs, or alterations to this product.
Epson America, Inc., shall not be liable against any damages or problems arising from the use of any options
or any consumable products other than those designated as Original EPSON Products or EPSON Approved
Products by Seiko Epson Corporation.

Trademarks
EPSON ® and ESC/P® are registered trademarks and ESC/P2 is a trademark ofSeiko Epson Corporation
General Notice: Other product names used herein are for identification purposes only and may be trademarks
of their respective companies.

Copyright 1994 Epson America, Inc

Epson America, Inc.
20770 Madrona Avenue, Torrance, CA 90509

Precautions
Precautionary notations throughout the text are categorized relative to
1. personal injury
2. damage to...