Caracteristicas

1. Antares GPS Description | |This mobile asset tracking & reporting communicator is ideal for commercial fleet management or private vehicle location systems. It combines the precision of GPS thepower of 2.5 and 3 G wireless networks. Available in GPRS and CDMA 800, 900, 1800 or 1900 MHz bands. Antares is compatible withy virtually any fleet management software.
ANTARES GPRS SPECIFICATIONS- Frequencys: 850, 900, 1800, 1900 Mhz.
- Full duplex communication.
- Receiver sensivity at antenna connector: < -102dBm
- Transmitter Output power: Class 4, 2W (33dBm).
- Antenna Impedance: 50Ohms.
- GPRS Speeds: Up to 114000 bps.
- Automatic start up.
- Antenna Connector: TNC type.
- Modulation: GMSK (Gaussian Minimum Shift Keying)
- SIM Card: 3/5 Volts.
- SIM Card PIN: Programmed byuser one time, automatically introduced onward.
GPS SPECIFICATIONS

General
- Frequency: L1 type.
- Channels: 8, continuous tracking receiver.
- Correlators: 32 GPS correlators.
Protocols:TSIP (Binary), NMEA 0183 (ASCII), TAIP(ASCII), DGPS.
Update rate: TSIP @ 1Hz, NMEA @ 1Hz, TAIP @ 1Hz.
Accuracy: 25m CEP (50%) w/o SA
Accuracy Velocity: 0.1m/sec
Antenna connector: MCX
Adquisition:Cold Start < 130 (90%), Warm Start < 45 seconds (90%), Hot
Start < 20 seconds (90%).
Readquisition after signal loss: < 20 seconds (90%NMEA
Messages:GGA, VTG, GLL, ZDA, GSA, GSV, RCM selectable byTSIP command.
2. UNIDADES SKYPATROL

System Requirements
Interface: Serial Host DSUB 9 connector
L x W x H: 4.0 x 5.0 x 1.6 in
Housing: One Piece, seamless Aluminum
Extrusion
TX Power: Class 4(2W @850/900 MHz)
Class 1 (1W @1800/1900 MHz)
Slot Class: MS10(4RX/2TX, 5 MAX)

Application Interface
• Host Protocols: PPP, AT Commands, UDP,
TCP/IP (future release)
• Internal Protocols: UDP,TCP/IP (future
release)
• API Control/Status: AT or UDP
• Friend‚s IP Feature
• Auto-Registration software upon power-up
• Over the air commands for:
- I/O Control - Status Change Reporting...