Manual denfort novamill

COMPUTERISED MACHINES AND SYSTEMSS

Operating Guide for the Novamill Series of CNC Milling Machines - Installation - Specific Features - Routine Maintenance

This manual applies only to the machine having the serial number shown below. Please note that this number will be required should Denford Limited be contacted regarding this machine. Machine Serial Number : ________________________ Yearof Manufacture : ________________________

Manufactured by Denford Limited, Birds Royd, Brighouse, West Yorkshire, HD6 1NB, England. Telephone: +44 (0)1484 712264. Fax: +44 (0)1484 722160. Email: service@denford.co.uk
NOVAMILL INSTALLATION GUIDE 1

CONTENTS.

Section

Page

Introduction. ................................................ 2 Warning....................................................... 2 EC Declaration of Conformity. ........................ 3 Unpacking & Lifting the Machine. ................... 4 Levelling & Positioning the Machine. ............... 5 Connecting the PC. ....................................... 6 Electrical Diagrams and Control Box Seal. ........ 6 Connecting the Mains Supply. ........................ 7 Component Connection Schematic Diagram. ....8 Removal of Protective Coatings. ..................... 10 Novamill - General Layout. ............................. 10 General Safety Precautions. ........................... 11 Install and Run the Machine Control Software. ..... 12 Automatic Search for Datum Point.................. 13 Maintenance Schedule................................... 14 Lubrication Chart.......................................... 14 Maintenance - Lubrication Points on the Novamill.... 15 Novamill Specification. .................................. 17 Denford Contacts, Products and Services. ....... 18

INTRODUCTION.

This guide will describe how to transport, site and setup your Denford Novamill CNC Milling Machine. Any operational features, specific to the Novamill range, are also covered in this guide. Generaloperating functions are explained in the separate "Generic CNC Milling Manual" delivered with your machine. A Routine Maintenance section is also included. Please note, the Electrical Diagrams for your machine are held in a folder fixed inside the electrical control box. IF YOU HAVE ANY DOUBTS AND/OR QUESTIONS REGARDING THE SPECIFICATION, SERVICING OR FEATURES OF YOUR MACHINE, PLEASE CONTACTCUSTOMER SERVICES AT DENFORD.

WARNING.

The Warranty on this machine will be invalidated if any modifications, additional ancillary equipment is fitted, or any adjustments made to the controlling devices without prior notification from Denford Limited. Do not carry out any portable appliance testing (PAT) on any of the supplied equipment.

2

- NOVAMILL INSTALLATION GUIDE

EC DECLARATION OFCONFORMITY.
The responsible person : Business Name : Address : ______________________________ Denford Limited. Birds Royd, Brighouse, West Yorkshire, HD6 1NB, England.

Declares that the machinery described : Manufacturer : Model Name : Serial Number : conforms to the following directives : Denford Limited. Novamill ______________________________ EC Machinery directive 89/392/EEC as amended bydirective 91/368 EEC and directive 93/44/EEC, CE marking directive 93/ 68/EEC and low voltage directive 73/23/EEC BS EN 60204 - 1 : 1993 ______________________________ and complies with the relevant health and safety requirements. Signature : Position within company : Signed at : ______________________________ ______________________________ Denford Limited, Birds Royd, Brighouse, West Yorkshire,HD6 1NB, England.

and the following standards :

NOVAMILL INSTALLATION GUIDE -

3

UNPACKING & LIFTING THE MACHINE.

Cut the top of the delivery box open and remove the styrofoam packaging carefully. To obtain better access to the machine and the power supply box, remove all the sides from the delivery box, leaving the machine standing on its wooden delivery pallet. Lift the power...